您要查找的是不是:
- Researching and Solving Methods for the Furnace Exit Flue Gas Temperature Large Deviation 炉膛出口烟温偏差问题的试验研究及对策
- The arithmetic improvement on furnace exit flue gas temperature of power station boiler and realization 电站锅炉炉膛出口烟温算法改进与实现
- Exit flue gas temperature 排烟温度
- The major factors is excess air and flue gas temperature. 影响注汽锅炉运行热效率的主要因素是排烟温度和空气系数,测算分析表明,大部分注汽锅炉二者均超标。
- Thereby, the efficiency would enhance while the flue gas temperature in back-end ductwork is appropriately chosen. 较低的尾部烟气温度有利于提高SO2溶解度,从而提高灰浆脱硫的能力。
- Using the model, numerical simulation of the flue gas temperature and speed deviation in the horizontal sack of the tangentially fired boiler before retrofit was performed. 利用该模型对改造前切圆锅炉水平烟道烟温、烟速偏差进了数值模拟,计算结果和实际运行状况一致,证明了模型的可行。
- The article will use the theory of combustion and heat transfer to analyze the affection of the orthometric elevation to the boiler compustion and flue gas temperature. 文章从燃烧理论及传热学原理出发,着重分析了海拔高度对煤粉炉内燃烧和锅炉排烟温度的影响。
- In order to satisfy the pulverized coal injection system for the requirements of flue gas temperature, the automatic control system of flue gas temperature is designed. 为满足喷煤粉系统在制粉过程中对烟气温度的要求,设计了烟气温度自动控制系统。
- Use several kinds of thermal calculation methods of boiler's furnace,and calculate the outlet flue gas temperature of a low load of some supercharged boiler. 运用几种热力计算方法,对某型船用增压锅炉低负荷工况的炉膛出口烟气温度进行了计算。
- Discussing the cause of flue gas temperature difference at furnace outlet in 4 corners tangentially coal fired boilers and proposing measures to eliminate such difference. 讨论了四角切圆燃烧锅炉炉膛出口烟温偏差的原因,提出了消除偏差措施的设想。
- Based on thermal dynamic theory,this article presents the calculation procedure for outlet flue gas temperature and vaporized water quantity of absorber for limestone-gypsum wet FGD. 根据热力学基本原理,提出了石灰石石膏湿法烟气脱硫吸收塔出口烟气温度及蒸发水量的计算过程。
- On same level of flue gas temperature, heating efficiency of hot air furnaces with input of cool flue gas should be high, different mixing media have a little influence on heat tran... 在受热面前的高温烟气中混入冷烟气或冷空气是降低壁温的有效方法。
- Testing and study on decreasing flue gas temperature deviation at furnace exit of 600 MW boiler unit 降低600 MW机组锅炉炉膛出口烟温偏差的试验研究
- Analysis and Adjustment of Boiler Outlet Flue Gas Temperature Difference 锅炉出口烟温偏差分析及纠正
- Effect of Flue Gas Temperature at Boiler Furnace Outlet on Boiler Performance 锅炉炉膛出口烟温对锅炉性能的影响
- Using the fitting results, the online measurement of flue gas dew point temperature was revised, and more exact flue gas dew point temperature at the exit of the CFTB reactor was acquired. 利用拟合结果对试验中在线测量的烟气露点进行修正 ,得到较准确的反应塔出口的烟气露点值。
- With this method, the temperatures of flue gas at the furnace and the stovepipe exit of a test boiler were calculated along with the changing of the flow rate of fuel gas. 通过计算得出了一台实验用相变-液浴式锅炉的炉胆出口烟气温度、排烟温度随天然气流量变化的曲线。
- Steam generation from this hot flue gas is a last resort option. 从这种高温烟道气生产蒸汽是一种最后的选择。
- It relied on exhaust gas temperature (EGT). 就靠排气的温度,看到的都是单线和双线的氧传感器。
- A fuzzy control strategy proposed for temperature control of the flue gas. 举例说明了烟气温度模糊控制器的设计过程。