该词条未找到_海词词典

您要查找的是不是：

Reliability of fault tolerant control system with Markovian parameters. 带马尔可夫参数容错控制系统的可靠性分析。
Finally, a system fault tolerant control method based on FDD (Fault Detection and Diagnostics) technology is designed. 设计了基于故障检测与诊断技术的容错控制方案。
The application of fault tolerant control and information fusion multi-sensors is studied in this paper for autonomous flight of pilotless helicopters. 摘要研究了将多传感器容错控制和信息融合技术应用于无人直升机的自主飞行控制。
Then based on linear and nonlinear flight models, fault tolerant control methods are introduced, which are largely divided into model based techniques and knowledge based ones. 然后根据线性和非线性飞机模型，分别介绍了相关的容错控制技术，主要分为基于模型和基于知识两大类。
Combining the generic model control(GMC),the strong tracking predictor(STP)and the strong tracking filter(STF),we propose an sensor active fault tolerant control approach for a class of nonlinear time-varying processes with input time delay. 通过结合非线性过程的一般模型控制(GMC)、强跟踪预测器(STP)和强跟踪滤波器(STF);本文提出了一类具有输入时滞非线性时变过程的传感器主动容错控制方法.
Passive fault - tolerant control 被动容错
fuzzy adaptive robust fault tolerant control 模糊自适应鲁棒容错控制
The key technology of fault tolerance control is online fault isolation and reconfiguration. 摘要容错飞控系统的关键技术就是进行实时故障隔离与重构控制。
The fault diagnosis and fault tolerant control to AMT 电控机械自动变速器的故障自诊断和容错控制
Robust lower guaranteed cost fault tolerant control for interval matrix systems 区间矩阵系统的保低成本鲁棒容错控制
Reliability of fault tolerant control system with Markovian parameters 带马尔可夫参数容错控制系统的可靠性分析
A Control Strategy with Neural Network for a Fault Tolerant Control System 容错控制系统的一种神经网络控制策略
At this point your logic is at fault. 在这一点上你的推理是错误的。
According to criteria and tolerance control standard,discussed control point and traverse layout accuracy calculating,as well as operating methods. 依照规范及限差控制标准,讨论了控制点布设、导线布设的精度计算以及作业方法。
A priest must learn to be tolerant and always suffer fools gladly. 一个神父必须学会宽容和永远甘心容忍愚妄的人。
R.O. Mittal, S.A. Irani, E.A. Lehtihet,“Tolerance Control in the Machining of Discrete Components”, Pennsylvania State University, University Park, U.S.A. 郑元杰，“多组加工特徵模式下工件切削之公差分配分析”，行政院国家科学委员会专题研究计画，元智大学工业工程系，1999.
The grumpy man found fault with everything. 那个性情乖戾的人对什么事都要找岔。
Of all the girls she was the most tolerant. 在所有女孩子中她是最宽容的。
It was not our fault that we were late. 这次迟到不是我们的错。
She was tolerant of different views. 她容忍不同的意见。