您要查找的是不是：
- The effects of aluminum bath temperature, immersion time and silicon content on hot dip aluminum for HT200 are studied. 研究了热浸温度、时间及硅含量对HT200热浸渗铝的影响。
- A hot dip Zn 5%Al RE coating on high carbon steel wire is tested. 试验了在高碳钢丝表面上热浸镀Zn 5%25Al RE合金层。
- Surface treatment of cold galvanizing, hot dip galvanized, plastic spraying, fire coatings, paint, and also produces aluminum alloy, stainless steel, glass steel, fire-retardant products such as cable tray. 产品表面处理有冷镀锌、热镀锌、喷塑、防火涂料、烤漆等，并且还生产铝合金、不锈钢、玻璃钢、阻燃等电缆桥架产品。
- Experiment results showed that the process of Hot Dip Aluminum and complex Boronisation on the A3 surface is feasible, it had a continuous layer between diffusion layer and matrix and a better hardness gradient. 试验表明 :A3钢表面浸镀扩散渗铝复合渗硼工艺可行 ,渗层与基体形成了连续的扩散层 ,并且具有良好的硬度梯度。
- The Annealing Furnace is a key Equipment for any Hot Dip Galvanizing Line. 对于任何连续热镀锌线退火炉都是关键设备。
- Good ductility and corrosion resistance. Gas welding and argon arc welding of pure aluminum. 塑性好、耐蚀。纯铝气焊、氩弧焊用。
- High structure strengh,hot dip galvanized,greatly protract time of use. 高强度管材、产品经热镀锌处理、大大地延长了使用寿命；
- Refining effect of boron on the hypoeutectic Al Si alloys and pure aluminum has been studied with SEM and XRD. 利用DSC，SEM 和X 射线衍射等手段， 分析了硼对纯铝及亚共晶Al?Si 合金的细化作用。
- Surface quality of hot dip plating Zn-Al alloy were further improved. 采用该合金助镀剂进行Zn Al合金热浸镀的样品 ,表面质量得到进一步改善。
- Adhensive Gasket:This product is made of pure aluminum foil and glue.Good sealing and good viscosity. 不干胶型垫片：本产品由纯铝箔与胶水经特殊处理而成。密封、粘贴性强。
- The defects of welding of pure aluminum are air hole, un interfuse, occlude and holding wolframium, etc. 纯铝在焊接过程中存在的主要缺陷是气孔、未熔合、夹杂及夹钨等。
- It was shown that comparatively high sili-con content in pure aluminum resulted in the occurrence of the surface veins. 结果表明，该灯罩材料中硅含量偏高是旱致“水纹”产生的主要原固。
- The driver chassie is a pure aluminum die cast contruction with an acoustically transparent design. 驱动器底座为纯铝铸结构，采用透声设计。
- The cold rolled coils entered into hot dip galvanizing workshop are put on waiting position and then transferred to uncoiler by coil car. 冷轧卷进入热镀锌车间后置于待处理位置,然后通过上卷小车送至开卷机。
- The effect of ECAP passes on materials mechanical properties of industrial pure aluminum L2 was investigated with equal channel angular pressing (ECAP) process . 利用等通道转角挤压(ECAP)技术挤压工业纯铝L2,探讨了挤压次数对其力学性能的影响。
- Commodity:Hot dipped galvanized steel in coil . 货物名称:冷轧热镀锌卷。
- In this study,the effect of ultrasonically melt treatment method on solidification structure of pure aluminum ingot was investigated,e. 用高效熔体处理技术制备试验用易拉罐用铝材,探讨了该技术对其铸态组织与力学性能的影响规律。
- The technique of hot dip Zn-Ni alloy coating is an effective method for solving the reactive steel problem in hot dip galvanizing. 热浸锌镍合金镀层技术是解决活性钢热镀锌问题的有效方法。
- It includes the mullite fiber, high alumunum fiber and pure aluminum fiber, which can be ade into the bulk fibers, fiber felts and feber paper. 分为莫来石纤维、高氧化铝纤维和纯氧化铝纤维，可制成纤维块、纤维毡、纤维板和纤维纸等制品。
- Effects of cooling rate on eutectic microstructure of Zn-(0.24Ni) alloy for hot dip galvanization were investigated. 研究了冷却速度对用于热浸镀Zn的Zn0.;24Ni合金共晶组织的影响。
