您要查找的是不是:
- Reducing Valve Socket 异径外丝束节
- When the proper temperature is reached alloy will flow readily into space between tube outer wall and valve socket. 达到适当的温度后,合金将迅速容易地流进管道外壳和阀门套管的间的空间。
- When the proper temperature is reached, alloy will flow readily into space between tube outer wall and valve socket. 当温度达到一定程度时,合金会很容易地流进管道外侧与阀门承插口之间的空隙中。
- Silver Brazing Method: Apply brazing wire or rod at point where tube enters valve socket. 银钎焊法:将焊线或焊杆点在阀门里的管道套座上。
- Valve assembly includes debris plug in valve socket end (to be removed on installation) and cable-tie affixed spare end connector. 阀门总成包括阀门承插连接端口内的碎片塞(安装时可拆卸)和电缆扎匝附带备用端口连接件。
- Cut tube end square to exact length needed, so that tube will enter valve socket all the way to the shoulder. Ream, burr and file. 根据所需长度垂直切割管道,使得管道能够完全进入到阀门插口的肩部。刮除毛刺,进行锉磨。
- Hand wheel,lever and spanner driving and safety valve,pressure reducing valve,traps overleap this symbol. 注:1、手轮、手柄和扳手传动以及安全阀、减压阀、疏水阀省略本代号。
- No relief valve is required where two pressure reducing valves are installed. 如果装上两个减压阀,就不需要安全阀。
- The installation of a water hammer arrestor (Watts Series 05) or water pressure reducing valve (Watts N35B) may be required to correct the problem. 这时可能需要安装美国瓦茨水锤制动器(美国瓦茨系列05)或水减压阀(美国瓦茨N35B)以解决这些问题。
- Air filtering pressure reducing valve, solenoid valve, valve location feedback device, valve gate locator, quick exhaust valce. 空气过滤器减压阀,电磁阀,阀位反馈装置,阀门定位器,快速排气阀。
- The water utility supply meter may contain a check valve, backflow preventer, or water pressure reducing valve. 自来水公司的供水水表可能包含一个止回阀,防倒流装置,或水减压阀。
- When flux appears liquid and transparent on both tube and valve, start sweeping flame back and forth along axis of joint to maintain heat on parts to be joined, especially toward the base of the valve socket. 当管道和阀门上的焊剂都变成液状和透明时,则开始沿着连接轴向前后来会扫着火焰,保持连接部件的温度,特别是阀门承插口底部的温度。
- Open the inlet stop valve gradually until the reducing valve takes control as indicated by the delivery pressure gage. 逐步开启进口截止阀,直到输出压力表上显示减压阀开始其控制作用为止。
- When flux appears liquid and transparent on both tube and valve, start sweeping flame back and forth along axis of joint to maintain heat on parts to be joined, especially toward base of valve socket. 当焊剂变成液态并且在管道和阀门上呈现半透明状态时,开始将火焰沿着连接部件的轴线进行进退烘烤,以保持连接部件、特别是阀门套筒底座部位的热度。
- Series 2300 is a direct operated, balanced, tight seating pressure reducing valve, opened and closed by small variations in delivery pressure. 系列2300是一种直接操作、平衡、紧密密封减压阀,根据输出压力的细微变化而开启和关闭。
- A single reducing valve can be applied if operating flow, requirements are within the capacity of one size valve, and pressure drop is outside the Cavitation Zone. 如果一个阀门通径可以满足工作流量和要求,并且压降处于空穴区外,则可以安装单个减压阀。
- Jumper Kits are used in new construction as a temporary by-pass, prior to the actual installation of a water pressure reducing valve on potable water supply systems. Jumper组件用于新在新的建筑内作为在饮用水供应系统上实际安装减压阀之前的临时性旁路。
- Install auxiliary (bleeder) pressure relief valve downstream of the reducing valve, in any convenient location where slight spillage is not objectionable. 在减压阀的下游安装辅助的(泄放)压力安全阀,可以安装在任何能够能够忍受轻微溢出的位置上。
- In view of the response lag in CVT ratio control, a control algorithm is proposed for compensating the response lag in proportional pressure reducing valve control. 针对系统固有的速比控制滞后,提出了能够补偿滞后的控制算法来对比例减压阀进行控制。
- The 2300 Direct Operated Reducing Valve is designed for deadend water service where the flow is intermittent and changes rapidly, as on domestic water systems. 系列2300直接操作减压阀适用于室内水系统流量有间歇性变化和变化迅速的终端水应用场合。