您要查找的是不是:
- anode voltage drop 阳极电压降
- Note the polarity of the voltage drop across R. 注意R上电压降的极性。
- The Ti-Ru anode voltage was measured during the electrolytic process. 测量了电解过程中钛涂钌电极的阳极电位。
- There is also considerable voltage drop in the consumer's internal wiring. 在用户内部接线中也存在相当的电压降。
- This creates a voltage drop, which can be measured to determine position. 这创建电压降,这可能被测量确定位置。
- Tells electrical voltage drop over distance, both for AWG and metric cables. 告诉电器的电压降超过距离,都为AWG的和公制的电缆。
- Thus, the terminal voltage drops to zero. 这样,路端电压就降到零。
- The amount of voltage used up for each resistor is called the voltage drop across that resistor. 每一电阻所消耗的电压量称为该电阻上的电压降。
- With the anode voltage and the cathode current changing,the variational process of the electron velocity ratio and spread is simulated,and the results of the average velocity ratio 1.1 and spread 9.5% are obtained. 在阳极电压和阴极电流变化的条件下;对电子速度比和速度零散随之而变化的情况进行了模拟;得到平均速度比1.;1和平均速度零散9
- To further enhance efficiency, the voltage drop across the tracking regulators has been minimized. 要进一步提高效率,需最小化跟踪稳压器过程中的压降。
- Allegro's A3901 offers a very small package size, low operating voltage and low voltage drop MOSFET outputs. Allegro的A3901具有小巧精致的封装尺寸,低工作电压和低电压降MOSFET输出的特性。
- The 1.5 Mohm resistance of the sensor provides extremely low power loss and voltage drop. 该传感器1.;5毫欧的电阻可确保极低的功率损耗和电压降。
- This is because voltage drop exists in each part of the power system from the generator to the customer's meter. 这是由于电力系统从发电机到用户电表的每一部分都存在电压降。
- The resistance must be calculated from the current and the resulting voltage drop using ohm is law. 根据电流和测出的压降值用欧姆定律计算出接地电阻。
- Usually, it is found to be capacitive and would cause a voltage drop in the time-domain reflectometry (TDR) waveform. 通常连通柱结构是呈现电容的效应,因此在输入讯号端可以观察到电容性的反射波形。
- As its resistance increases, its voltage drop increases and, though small, can be measured without difficulty. 因为它的阻抗增加,它的电压降落增加,虽然小,可能被测量没有困难。
- anode voltage stabilized camera tube 高速电子束摄象管
- In steady-state, DVR can be used to compensate the voltage drop caused by circuit reactance. 在稳态方面,由动态电压调整器来补偿线路电抗所造成的压降,提高电压之稳定性。
- The current is sourced through the two outer probes and the voltage drop is measured between the two inner probes. 电流从两个外部的探针加入,而电压降则在两个内部的探针之间测量。
- Figure 3-17 shows the voltage drop of a DUT as a function of time with an alternating polarity current applied. 图3-17表明在加入极性交替的电流时,被测元件(DUT)上的电压降与时间的函数关系。