您要查找的是不是：
- belt tensioning idler pulley 紧带惰轮
- Loosen the accessory drive belt at the power steering pump bracket, if equipped or at the idler pulley bracket (refer to Group 7, Cooling System for the proper procedure). 如果装备且在惰轮皮带盘托架上，放松动力转向泵托架上的附件驱动皮带。
- End Cap: Belt Tensioning System, easy access, easy adjustment. 完第：皮带张紧系统，方便，调整方便。
- The waviness is mainly depending on the belt tension. 该波纹是主要依靠皮带张力计。
- If the offset of the idler pulley location appear,the sensor can change the off... 经实验验证,该传感器可达到良好的测量和监测效果。
- Inverse Analysis on Clutch of Belt Tension Pulley 皮带张紧轮式离合器反求分析
- We also supply various of ceramic, resin and rubber bonded wheels, centerless wheels, rubber idler pulley, resin two-side grinding wheels. 各种规格、尺寸、形状的陶瓷、树脂、橡胶结合剂的平行（异形）、无心磨轮、橡胶导轮、树脂双端面磨砂轮。
- Check and repair radiator and thermostate; adjust the fan belt tension. 检查并修理散热器、调温器，调整风扇皮带张紧力。
- For explaining auto-system, this paper explains several kinds of sensor.This paper selects idler pulley, CCD sight sensor and light electic sensor as sensor to measure the location of weld beam. 在自动化系统设计的论述中，主要介绍几种常用的测量元件，并且选择了导轮跟踪、CCD视觉传感器和光电开关来测量焊缝的位置，并介绍了这些传感元件的设计和应用。
- For belt tension specifications, refer to Specifications-Accessory Drive Belt in this group. 关于皮带张力规格表，请参见本单元的规格表-辅助驱动皮带
- The lab test result shows that this system is feasible for dynamic test of belt tension. 系统能实现输送带静止及运动过程中的沿线张力测试。
- Some movement of sprockets and timing marks as belt tension is adjusted is normal. 当调整皮带张力时，链轮与正时记号有些许移动是正常的。
- Lacking in automatic belt tensioning structure, the new HAUNI belt weigher has a problem of tare drift in the run-time. The article introduces a new solution to the problem. 摘要新型HAUNI电子皮带秤缺少皮带自动张紧结构，在运行时会产生皮重漂移问题，文章介绍了一种解决电子皮带秤皮重漂移的新方法。
- Usually the same belt drives the alternator, and belt tension is adjusted by swinging the alternator on its mounting. 通常将一台机器的皮带换到另一台机器的时后，带的张紧力需要通过调节安装来调节。
- Height of the front idler pulley from the floor 前端导轮离地面高度
- Loosen the accessory drive belt tension and remove the belt from the power steering pump (refer to Group 07, Cooling Systems for proper procedures). 放松辅助驱动皮带，从动力转向泵上拆下皮带（有关程序，请参阅单元07，冷却系统）。
- In this mechanism, two co-axial pulleys with different diameters are fixed between the driving pulley and the idler pulley in a traditional timing transmitting system. 该机构是在传统的同步带机构的主、从动轮之间加上一套由大小不同的两个同轴固联在一起的差动轮组成的差动传动机构。
- The 0.5 hp motor was mounted on vertical rails at the back of the headstock-end leg and could be moved up and down, to adjust the belt tension. 0.;5马力电机安装在垂直导轨背面的启闭年底腿，可以向上和向下移动，以调整皮带的紧张局势。
- One or two flow-paths of idler pulleys and impellers of ESP are often jammed owing to the restraint of the foundry technique. 据此,研制了一种新颖可靠的电潜泵导、叶轮流道检测仪。
- If this is not the case, the bearing must be subjected to an additional radial load, e. G. By increasing belt tension or idling torque, or by other means. 否则必须给轴承施加径向载荷,例如,通过提高皮带张力或空转扭矩,或采用其他手段。
