您要查找的是不是：
- bilge pump suction pipe 舱底泵吸水管
- Suction piping for all pumps shall have at least five(5) times the nominal pump suction flange diameter of straight pipe upstream of the suction nozzle. 所有水泵的吸水管道直径至少应有5倍于吸入口的上升直水管段的额定边缘直径。
- Suction piping for all pumps shall have at least five (5) times the nominal pump suction flange diameter of straight pipe upstream of the suction nozzle. 所有水泵的吸水管道直径至少应有5倍于吸入口的上升直水管段的额定边缘直径。
- direct bilge pump suction 直通舱底泵吸管
- Open pump suction venting valve until gas free. 打开泵入口管线上的放空阀，至无气体。
- Stop: Shut off the valve for the suction pipe. 停机：1、关闭吸入管阀门。
- oil pump suction pipe gasket 油泵吸油管密封片
- pressure pump suction pipe 压力泵吸油管
- feed pump suction pipe 添水泵吸管
- Switch on bilge pumps in engine room and report. 启动机舱污水泵并报告。
- All bilge pumps are operational. 所有救生艇排水泵正常。
- pump suction pipe 泵吸入管
- water pump suction pipe 水泵吸水管
- Confirm line up, tank outlet and pump suction valve keep free open. 确认流程已通，罐出口及泵入口的阀门保持全开。
- Switch over bilge pumps from port to starboard side. 将污水泵工作从左舷切换到右舷。
- air pump suction pipe 气泵吸管
- circulating pump suction pipe 循环水泵吸水管
- Operation test of emergency switching-off device for oil pump and ventilator (bilge pump) in engine room. 机舱风、油(舱底泵)应急切断装置操作试验。
- Finish coat for engines, gas suction pipes, etc. 适用于发动机、输气管道等的面漆。
- The next steps will be to route the receiver antenna outside the WTC, cut off the battery terminal poles and also figure out what to do with the bilge pump light. 接下来的步骤将是路线，接收天线以外的世台会，切断电池终端两极并计算出该怎么办与舱底泵轻。
