您要查找的是不是：
- broken parting line 折分模线
- Parting line at the acceptable surface. 合模分布在合理可接受的表面。
- Parting line cleared and released properly? 分模线是否正确?
- Parting line locks are required on all molds. 琐模块所有的模具都需要。
- He insisted on a replacement for the broken part on my bycicle. 他硬要换掉我自行车上破的零件。
- The parting line tolerance for gib installation is +.000/-.002. 安装导板的分模线公差为+.;000/-
- The glue will hold together the broken parts. 胶水会把破裂的部分粘在一起。
- The broken part must fuse with the rest of the bone before you can walk. 骨折的部位必须接好复原后你才能下地走路。
- The broken part must fuse with the rest of the bone before you can walk again. 必须等断骨长合以后, 你方能走路。
- The broken parts we have replaced are aluminum ones. 我们已换掉的破零件是铝制零件。
- There's an undercut at this position and it needs a slider. It will also have a parting line on this side, is that OK? 产品的这个位置不能出模,我们打算做行位,在此面上会有分模线,你接受吗?
- Becasue of hand deflashing, please mark the parting line into the drawing, and please let me know then the flash size. 因为手遮光，请将分界线在图中标出来，并告诉确切尺寸。
- It is no use to adjust the pressure unless the broken parts are changed. 除非把破损的部件都换掉,否则调压是没有用的。
- I've put most of the broken parts together but I can't fit this piece in. 我已经将大部分碎片拼起，但这一块却拼不上去。
- Mould halves requiring accurate alignment of core and cavity, and shut off should have appropriate part line locks. 上、下模需要精确配合或有擦位的地方,模具一定要有直身锁。
- The parting line at ends of block should be designed such that any offset is in 1"increments for maintenance purposes on core. 考虑到动模维护需要,封胶面应有1”左右的偏移增量。
- Although, some computers do provide a way to disable a malfunctioning device which will allow you to install your own store bought device to take the place of the broken part. 虽然有些电脑确实提供了一种失灵装置失灵;使你自己的商店设置买仪器代替了部分破碎.
- But for medium thickness pipe DWTT,it usually converse fraction of figure transforming much in break part,and make specimen failure. 但是中厚壁钢管DWTT试验经常产生解理断裂部分塑性变形大的逆向断口 ,使试样无效。
- The optimization parting direction was determined after all undercut features were distinguished, and the parting line and parting surface were confirmed accordingly. 通过侧凹特征的判别确定模具的优化脱模方向，并确定模具的分型线和分型面。
- The selection of parting line,the determination of round sprue runner diameter,the design of round sprue runner shape and pouring gate form were presented. 介绍了模具分型面的位置选择、圆形流道直径的确定、圆形流道形状的设计、浇口形式等。
