您要查找的是不是：
- The stick of carbon is often used in an electric arc lamp. 碳精棒常用于电弧灯。
- Feasibility Study on the Substitution Xenon Arc Lamp for Carbon Arc Lamp in Light Acceleration Weathering Test 光老化处理中氙弧灯替代碳弧灯的可行性研究
- carbon arc lamp 炭棒弧光灯
- open carbon arc lamp 室外碳极弧灯
- high-intensity carbon arc lamp 高强度碳弧灯
- flame carbon arc lamp 发光碳精棒弧光灯
- three-phase carbon arc lamp 三相炭弧灯
- enclosed carbon arc lamp 封闭式碳极弧灯
- crater carbon arc lamp 陷口式碳弧灯
- The arc lamp is very useful in movie shooting, and screening. 弧光灯在电影拍摄和放映的过程中有很大的用处。
- Arc lamps require a current-limiting ballast. 弧光灯需要一个限流镇流器。
- Choice a xenon arc lamp, it uses air-cooled, full-spectrum, 2000W. Recommends replacing lamp every 1500 testing hours. 选用1只美国原装进口风冷式氙灯光源;功率2000W;建议试验时间达1500小时后进行更换.
- Light from a mercury arc lamp will produce fringes over a range of one or two centimeters. 汞灯泡发出的光产生一到二厘米范围以上的条纹。
- "Indoors, light is furnished by carbon arc lamps, incandescent bulbs, and quartz bulbs. The basic indoor lights are Spotlights and floodlights. Spotlights throw a beam of concentrated, intense light." 室内光源有碳弧光灯，白炽灯及石英灯等。室内的主光源是聚光灯和散光灯、泛光灯。聚光灯将光聚到一起。
- EMEM may replace emery wheel grinding, carbon arc gouging operation in certain applications. 数控电熔爆机床可在某些加工场合取代金刚石砂轮磨削、碳弧气刨加工。
- The thermal oxidation, photo-oxidation properties of PE-LLD with or without the complex were studied using TG, xenon arc lamp, and IR. 研究表明,该铕配合物对PE-LLD的光氧化过程有明显的阻滞作用,而对其热氧化过程则有加速作用,对材料老化性能总的影响取决于二者的综合。
- A carbon arc set-up and a modified glow discharge apparatus for the preparation of carbon stripper foils are described. 采用辉光放电裂解乙烯法和碳弧法，为串列加速器制备了长寿命碳剥离膜。
- No colour fade after 300 hours close distant exposure to arc lamps. 以炭精弧光灯近距离照射300小时，油漆没有褪色。
- And it also brings forward the security protection of noise,arc and dust in process of carbon arc air gouging. 并提出了碳弧气刨过程对噪声、弧光以及粉尘的安全防护。
- The available ignition circuit for large power xenon short arc lamp is improved to match direct low voltage supply and the new igniter can be used with DC power on board. 为了使大功率短弧氙灯能在低压直流供电的情况下顺利点燃,对现有触发电路进行了改进设计,使其适用于低压直流电源。
