您要查找的是不是：
- cavitation sensor 汽蚀传感器
- Cavitation can be caused by a variety of reasons. 气穴可以由各种原因引起。
- Cavitation is noisy and easily detected by sonar. 空泡现象是有噪声的并且容易被声纳探测到。
- It explores the most conditions of cavitation. 探索了最优空化强化条件。
- He plugged the sensor into a outlet. 他把传感器插进电源插座。
- He perfected a flux-gate sensor in 1941. 他在1941年制成了一台磁通脉冲传感器。
- Old Technology: Based on PIR motion sensor. 传统技术：基于PIR运动传感器。
- The torques are recorded with a torque sensor. 采用扭矩传感器记录扭矩。
- The oscillation of a laser-generated cavitation bubble near a solid boundary is investigated with a home-made optical fiber sensor. 采用自行研制的光纤传感器研究了激光等离子体空泡在固壁面附近的脉动特性。
- Areas of necrosis and cavitation may occur within the tumor. 肿瘤内可以有坏死和成腔区。
- ARE ANY WHEEL SPEED SENSOR TROUBLE CODES PRESENT? 是否存在一些轮速故障代码?
- This is the basis of the phenomenon called cavitation. 这就是所谓汽蚀现象的根据。
- DISCONNECT THE TRANS RANGE SENSOR (TRS) CONNECTOR. 断开变速箱范围感知器（TRS）接头。
- Disconnect electrical connector at sensor. 在感知器处断开电气接头。
- Disconnect vehicle speed sensor wires. 断开车辆速度感知器电线。
- Disconnect wires from vehicle speed sensor. 从车辆速度感知器断开电线。
- The total diameter of cavitation, if present, is less than 4cm. 若出现空洞，其直径总和小于4厘米。
- DISCONNECT THE INPUT SPEED SENSOR. 拆除输入速度感知器。
- INSPECT THE LF SENSOR CONNECTOR. 检查左前感知器接头。
- Excessive noise is an indication that cavitation is occurring. 噪音太大是发生空洞现象的一个征兆。
