您要查找的是不是:
- clock pulse frequency 节拍脉冲频率, 时钟脉冲频率
- Trigger control circuit from complex programmable logic device (CPLD), ICL7135CN, the clock pulse circuit and optocoupler inverter constituted. 触发控制电路由复杂可编程逻辑器件(CPLD),ICL7135CN,时钟脉冲电路、反相器和光耦构成。
- Hardware pulse distribution, and can be controlled stepper pulse frequency to the governor. 硬件脉冲分配方式,可以控制步进脉冲的频率来调速。
- Increase in intensity,retention time and the pulse frequency could enhance the efficiency. 增加磁场强度、处理时间和脉冲频率可以提高杀菌效果.
- If the host pulls clock low before the first high-to-low clock transition, or after the falling edge of the last clock pulse, the keyboard/mouse does not need to retransmit any data. 如果在第一个高->低时钟跳变时,(或者在最后一个时钟脉冲的下降沿之后)主机将时钟拉低,键盘/鼠标不必重新传输任何数据。
- Describes a new design of pulse frequency dividers in which timers NE556 and sequencecontrol unijunction transistors are used. 利用定时器NE556和程控单结晶体管,设计了一种新型多路脉冲分配器。
- Based on the model,the relationship between the main pulse frequency of supply power and the balanceable inter-electrode gap is discussed. 给出了脉冲电化学加工极间平衡间隙的数学模型,并据此讨论了高频群脉冲电化学加工中,电源主脉冲频率与平衡加工间隙的关系。
- If the host pulls clock low before the first high-to-low clock transition, or after the falling edge of the last clock pulse, the keyboard/ mouse does not need to retransmit any data. 如果在第一个高->时钟跳变时,(者在最后一个时钟脉冲的下降沿之后)机将时钟拉低,键盘/标不必重新传输任何数据。
- If the host pulls clock low before the first high-to-low clock transition, or after the falling edge of the a last clock pulse, the keyboard/mouse does not need to retransmit any data. 如果在第一个高->低时钟跳变时,(或者在最后一个时钟脉冲的下降沿之后)主机将时钟拉低,键盘/鼠标不必重新传输任何数据。
- Switching Power Supply has three kinds of control circuits: Pulse Width Modulation (PWM), Pulse Frequency Modulation (PFM), Pulse Width and Frequency Modulation (PWM-PFM). 开关电源有三种控制方式:脉冲宽度调制(PWM)、脉冲频率调制(PFM)、脉冲宽度频率调制(PWM-PFM)。
- The parallel loading of the flip-flop can be synchronous (i.e., occurs with the clock pulse) or asynchronous (independent of the clock pulse) depending on the design of the shift register. 触发器的并行加载可以是同步的(即在时钟脉冲到达时发生)或异步的(不依赖于时钟),这取决于移位寄存器的设计。
- Laser scribing of InSb with a Q switched Nd:YAG laser was studied in this paper and the relationship between pulse frequency and groove depth and width has been obtained. 研究了利用调 Q Nd: Y A G 激光对 In Sb 的激光划片,得出了刻槽深度和宽度与脉冲重复频率之间的关系。
- Multiple functions available : start/crater arc current, increase/decrease time,base/crest value current,pulse frequency,pulse rate,post flow time, HF welding. 功能丰富:起始/收弧电流、上升/下降时间、基值电流、峰直电流、脉冲频率、占空比、滞后关气时间分别可调,高频引弧。
- A microprocessor designer may decide to make all instructions last five clock pulses. 微处理机设计人员可以决定使所有的指令持续五个时钟脉冲。
- NEB delays the time of first ovulation through inhibition of LH pulse frequency and low levels of blood glucose, insulin and insulin-like growth factor-I (IGF-I). NEB可通过抑制LH脉冲频率、降低血浆葡萄糖、胰岛素和胰岛素样生长-1(IGF-I)因子浓度,从而造成奶牛分娩后首次排卵间隔延长;
- The Increase of pulse voltage and pulse frequency is beneficial to refinement and improvement of solidification structure of hypereutectic gray cast Iron. 脉冲电压的升高和脉冲频率的增大都有利于过共晶灰口铸铁凝固组织的细化和改善。
- Furthermore the dependence of etching current were proved on laser parameters(pulse number and pulse frequency) and that the excimer laser have the abili... 表明准分子激光在钝化区具有增强电化学特性的能力。
- Note that a set of lights attached to O1, O2, O3 would display the numbers of full clock pulses which had been completed, in binary (modulo 8), from the first pulse. 注意,一组接在O1,O2,O3上的灯泡将以二进制(模8)形式显示第一个脉冲以来已完成的完整时钟脉冲数。
- In binary synchronous communication, the use of clock pulses to control synchron ization of data and control characters. 在二进制位同步通信中,使用时钟脉冲来控制数据和控制字符的同步。
- The increase of current density and pulse frequency can be helpful to refine and improve the solidification microstructure of the pure aluminum at a given pulse current range. 在一定的脉冲电流参数范围内,电流密度增大和脉冲频率升高都有利于金属凝固组织的细化和改善。