您要查找的是不是:
- A high-voltage output flyback converter operating in DCM was designed. 设计了一种工作在不连续导电模式(DCM)下的高压输出反激变换器。
- The flyback converter employs a proprietary algorithm to rapidly charge the photoflash capacitor to desired voltage. 反激转换器使用独有的算法将照相闪光灯电容器快速充电至所需电压。
- A flyback converter with zero current switching (ZCS) resonant and power factor correct (PFC) is proposed. 提出了一种具有零电流关断(ZCS)的反激式单级功率因数校正(PFC)变换器。
- Detailed operation of the secondary side post regulation application in flyback converter is discussed. 详细分析了一种运用了后极调整技术的多路输出反激变流器的工作原理。
- The output power of interleaved flyback converter is two times high than that of flyback converter. 交错反激变换器可将反激变换器的输出功率提高1倍。
- Single flyback converter circuit, as well as the PWM signal, is used to control the MOSFET. 使用单端反激变换器电路,用PWM信号控制开关管MOSFET。
- Circuit characteristic is composed with forward converter and flyback converter. 因此本论文利用间接型滑动模式控制法则以稳定系统之输出电压。
- At last, a prototype based on the novel interleaved flyback converter is accomplished and experimentally verified. 最后在此理论分析的基础上研制了一台原理样机,并通过实验验证了理论分析的正确性。
- Current mode control is used for the flyback converter for its good line regulation. 回扫转换器工作在电流控制模式能够有很好的线性调整。
- A single-end flyback converter with multiplexed output for IGBT drive based on UC3844 is presented. 介绍一种采用UC3844集成芯片实现的多路输出单端反激式IGBT驱动电源。
- The power supply is based on a quasi-resonant, discontinuous flyback converter, operating near the critical conduction boundary. 电源供应基于准共振间断反激转换器,该设备可在临界传导边界附近工作。
- In this paper a novel interleaved flyback converter with clamp capacitor was present.Its working principle was analyzed in particular. 该文提出了一种新颖的带有箝位电容的交错反激变换器并详细分析了其工作原理。
- The power-supply design in Figure 1 is a blocking oscillator that operates as a flyback converter with fixed on-time and variable off-time. 图1中电源设计为带确定作用时间和变间隙时间的反激式转换器间歇振荡器。
- An introduction to a type of lossless snubber circuit applicable to flyback converter was given,and its working principles were analyzed. 介绍了一种反激式变换器零电压关断缓冲电路,同时分析了其工作原理。
- However, due to leakage effects flyback converter power switch off when the voltage spike caused by the need to be inhibited by clamping circuit. 然而,由于漏感影响,反激变换器功率开关管关断时将引起电压尖峰,必须用钳位电路加以抑制。
- Zhao, Q., F.C.Lee and F.S.Tsai,“Design Optimization of an Off-Line Input Harmonic Current Corrected Flyback Converter, IEEE APEC, pp. 91-97, 1999. 刘智豪,“单级隔离式高功因电力转换器之模式分析及控制器设计”,硕士论文,国立成功大学工程科学系,2000。
- The difference between a hard switching and quasi resonant flyback converter is the turn on time point of the primary switch. 硬开关和准谐振反激变换器之间的差异在于一次侧开关的开启时间点。
- As soon as the flyback converter leaves the VCO mode, the power factor correction circuit restores normal operation immediately. 一旦回扫转换器离开了VCO模式,这个功率因素调整电路重新立即恢复到通常的操作模式。
- Firstly, different operation modes of flyback converter are analyzed and compared, technique of RCD clamp in flyback converter is researched. 首先分析比较了反激变换器的不同工作模式,对RCD筘位技术进行了研究。
- The post-stage circuit is functioned to transform from DC voltage to the rated DC voltage of load with the structure of flyback converter. 后级再将直流电压转成负载所需之直流工作电压,其架构为返驰式转换器。