您要查找的是不是:
- Use : Purpose :hierachial machine extensively suitable for metal ore dressing procedure go on grain size grade to ore pulp ,take off the mud ,dephydrates ,often makes up the closed procedue with the ball mill when can be used for wshing the homenork. 用途:螺旋分级机广泛适用于金属选矿流程中对矿浆进行粒度分级,也可用于锡矿作业中脱泥、脱水,常于球磨机组成闭路流程。
- grain size grade 粒度等级
- So the grain size of the gear steed must be maitained above No 6 grade. 因此,必须严格控制其晶粒度,使之为6级以上。
- There is a general decrease in grain size upward. 粒度一般是向上递减的。
- Rough and loose structure for rough grain size. 接触面积大时用粗松的组织。
- Fine grain size for the smaller contact area. 接触面积小时用细的粒度。
- Coarse grain size for the larger contact area. 接触面积大时用粗的粒度。
- Grain size of the sample had been measured. 降尘量和粒度参数值在尘暴前期和后期都呈现不同特征。
- The grain size distribution was bimodal as a whole. 尘暴降尘的粒度基本呈双峰态分布。
- Its equidimensional grain size tends to mask the laminae. 它的粒度的均一往往会掩盖了纹层层理。
- Our pure Cobalt plate has typical purity grade of 99.95% -99.999%, the PTF can reach 85% and above, Grain size is typically within 100 microns. 我们生产的纯钴块纯度从99.;95%25到99
- Abstract: The strength and toughness of super-fine grain steels are greatly increased because of its micrometer or sub-micrometer grade grain size. 摘 要: 超细晶粒钢依靠生成微米级或亚微米级的铁素体,使钢的强度和韧性大大提高。
- Grain size had some effect on the rate of crack propagation. 晶粒尺寸大小对裂纹扩展速率也有影响。
- Type O steel shall be supplied without specific grain size control. 0类型的钢没有特殊的颗粒尺寸控制。
- Fine-grain (grain size <0.5 mm) aluminosilicate concrete. 细颗粒(粒度小于0.;5毫米)的硅铝酸盐混凝土。
- The best rubbing time and grain size are given in the paper. 文中给出了最佳的样品研磨时间及粒度。
- The relationship be-tween grain size and fractal dimension is investigated. 考察了晶粒度与分维之间的关系。
- They impinge on the final structure, grain size and properties of this alloy. 他们对最终组织、晶粒尺寸和合金性能都有较大的影响。
- The grain size is measured to be above ASTM grade 11.0 for low temperature coiled Ti-IF steel as well as Ti-Nb-IF steel containing higher carbon content or to be about ASTM grade 10.5 for high temperature coiled Ti-IF steel, respectively. 热轧低温卷取Ti-IF钢和碳含量较高的Ti-Nb-IF试验钢的铁素体晶粒度在11.;0级以上;热轧高温卷取Ti-IF钢在10
- It was found that during the electrodepositing process, the grain size of the welding seam and that of the matrix metal is not the same grade so that the current distribution in the cathode is uneven. 研究发现,在电解铜箔生产中,阴极辊表面焊缝处组织与基体金属组织晶粒尺寸不同级,因此电流在阴极上分布不均匀,在相同时间内沉积的铜箔厚度也不均匀,厚度差引起铜箔色差,形成光亮带;