您要查找的是不是:
- Another consideration when measuring voltages from high resistance sources is the input bias current of the voltmeter. 在测量高电阻源时要考虑的另一个问题是电压表的输入偏置电流。
- However, also consider amplifier noise, input bias current, offset voltage, MDAC resolution, and glitch energy. 然而,也要考虑放大器的噪声、输入偏置电流、偏置电压、MDAC分辨率和毛刺能量等因素。
- The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage. 仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。
- Picoammeters and SMUs also have very low input bias currents, although usually not as low as an electrometer's. 皮安计和SMU也具有很低的输入偏置电流,但是通常没有静电计低。
- Input offset current is the difference between the two input bias currents and this leads to offset errors in in-amps when source resistances in the two input terminals are unequal. 输入失调电流是两个差动输入端的基极输入电流,当两个输入端的源阻抗不相等时,它可引起仪表放大器的失调误差。
- Very low input bias current: 1 pA typical 极低的输入偏置电流:1 pA(典型值)
- The combination of low offsets, low noise, very low input bias currents, and high speed make these amplifiers useful in a wide variety of applications. 低失调、低噪声、极低的输入偏置电流和高速度特性相结合,使这些放大器适合各种应用。
- For minimum error due to input bias current 最小误差由输入偏置电流引起
- OP1177: Precision Low Noise, Low Input Bias Current Operational Amplifier (Single) OP1177:高精度、低噪声、低输入偏置电流单运算放大器
- input bias current 输入偏置电流
- I added a switch that allows the bias current to be changed. 我加了一个开关来改变偏置电流。
- This current is known as the input offset current, and it's caused by bias currents of active devices as well as by leakage currents through insulators within the instrument. 这种电流称为输入偏置电流,是由有源器件的偏置电流以及流过仪器内部的绝缘子的泄漏电流所引起的。
- When JFET is used as a low-noise and high-operational amplifier in input tube, plate fond and back grid can be separated to decrease input bias and increase input impedance. 在JFET作输入管的低噪声高精度运放中,为了进一步减小输入偏流,增大输入阻抗,可使顶、背栅分离,且仅以顶栅接输入信号,而背栅接片内控制电路。
- Low Input Bias and Offset Current Errors 低输入偏置电流和失调电流误差
- The DAC transfers the data stored in EPROM to the gate of MOS transistor so as to control the bias current, and tune the responsivity of detector and dummy detector. 用数模转换器将存储在EPROM内的偏置电压输出到MOS管的栅极上,实现对偏置电流的控制,调节探测元及补偿元的响应率。
- Square waves are superimposed on a constant bias current to determine the time constants under diversiform over heat ratios. 对该剪应力传感器进行了方波实验,确定其工作在不同过热比下的时间常数。
- The thesis introduces analog multiplier MC1496 of motorola company mainly about its internal structure and setting of quiescent offset voltage and quiescent bias current. 介绍了MOTOROLA公司生产的集成模拟乘法器MC14 96的内部结构及静态偏置电压、电流的设置。
- The maximum on-time is kept as a constant and a bias current of the oscillator in the PWM controller is moderated to achieve the off-time modulation. 截止时间调变的功能是藉由保持固定的最大导通时间,并且调整PWM控制器之振荡器的偏压电流来达成。
- The recovery time at this node following a slewing transient must be taken into consideration when choosing the bias current in M5. 跟随回摆瞬态的,此节点处的恢复时间,在选择M5中的偏置电流时必须考虑进去。
- The experiment platform of single freedom , bias current and small signal test current ,and displacement test current are designed and fabricated. 设计、制造了单自由度自检测磁悬浮试验台、偏置测试电路和位移检测电路。