您要查找的是不是：
- High-Q tuned LC filters will have more insertion loss. 高Q值调谐LC滤波器会有更多的插入损耗。
- Method of insertion loss measurement for radio frequency filters. 射频滤波器插入损耗的测量方法。
- High Finesse and Low Insertion Loss Fiber Fabry-Perot Filter[J]. 引用该论文 廖青;彭江得;周炳琨.
- The next page explains the concept of insertion loss. 下一单元解释插入损失的观念。
- Practically : Including connector, balun insertion loss and amplifier gain. 实际 : 包含接头、平衡非平衡转换器损失、放大器增益。
- They have high reflection losses and isolates degree, lower insertion loss. 具有高的反射损耗和隔离度，较低的插入损耗。
- Feed through filters provide high Insertion loss over a broad band of frequencies from KHz to GHz frequency levels. 馈通式滤波器在宽频范围从KHz到GHz段,提供高插入损耗。
- Specialties: Small Dimension, Low Insertion Loss, High Restraint Outside the Band and High Reliability. 特点:可实现的滤波器的体积小,插入损耗小,还外抑制高,可靠性高。
- Following the side-band filter is an amplifier which makes up for the filter insertion loss. 边带滤波器后面接了一个放大器，以便补偿该边带滤波器的插入损耗。
- The total insertion loss of the MMI-AWG is 5.72dB, thecrosstalk is better than ?30dB, and the PDL is less than 0.5dB. 同时;器件插损为5.;72dB;串扰优于-30dB;PDL小于0
- Insertion loss of 2.4 db and isolation ratio of 34.8 db were obtained at 1.15 m wavelength. 在波长为1.;15微米时;器件插入损耗为2
- Specialties : Small Dimension, Low Insertion Loss, High Restraint Outside the Band and High Reliability. 特点：可实现的滤波器的体积小，插入损耗小，还外抑制高，可靠性高。
- Some of these considderationsinclude insertion loss, cross talk, propagation delay, and unterminated stubs. 需要考虑的因素包括插入损耗、串扰、传输延迟和未端接短截线。
- Although a number of vias are adopted in the circuit design, it does not lead to the increase of the insertion loss. 虽使用为数众多之金属贯孔，但其穿透损耗并未明显增加。
- It is characterized by good frequency selectivity, low insertion loss and high attenuation of specified frequency. 它具有频率选择性好，通带插损低，对陷波频点抑制较高的优点。
- Theoretically : Connector, balun insertion loss and amplifier gain are not included. 理论 : 不含接头、平衡非平衡转换器损失、放大器增益。
- This technique has the advantage of compact circuit size without increasing the insertion loss. 此方法具有不会增加电路面积与植入损耗之优点。
- Starting with the definition,the insertion loss of grids with different specification is measured by hydrophone method. 在理论上给出插入损失的定义,实验上用水听器法测量了不同规格网格的插入损失。
- An ultra low insertion loss GaAs MMIC RF SPDT switch based on full-ion-implantation technology is reported. 报道了利用离子注入技术研制出一种用于手机的超低插损砷化镓单片射频单刀双掷开关。
- On the basis of predefined waveguide parameters,insertion loss and crosstalk of this device has also been analyzed. 然后根据所确定的器件结构参数，对该器件的插入损耗和隔离度进行分析。
