您要查找的是不是:
- When mixing the MDI and PF,adding the MDI first has higher IB (internal bond strength) and TS(thickness swelling of the board) than adding the UF first. 按照不同的施胶顺序将异氰酸酯与不同的酚醛胶混合。 结果表明:先施加异氰酸酯再施加PF与先施加PF再施加异氰酸酯相比,板材的内结合强度和厚度膨胀率好;
- Effect of Laccase Treating Conditions on Internal Bond Strength of Liquidambar formasana Fiberboard 漆酶处理条件对枫香湿法纤维板强度的影响
- Effects of Horizontal Density Distribution on Internal Bond Strength of Particleboard 平面密度分布对刨花板内结合强度的影响
- Keywords laccase;liquidambar formasana;fiberboard;treatment conditions;internal bond strength; 漆酶;枫香;纤维板;处理条件;内结合强度;
- Keywords Phenol formaldehyde resin;Kenaf felt board;Internal bond strength;Thickness swelling rate of water; 酚醛树脂;麻毡板;内结合强度;吸水厚度膨胀率;
- internal bonding strength 内部结合力
- internal bond strength 内部结合力
- could improve the thickness swelling and water absorption of GPB, and also improve the internal bond strength( IB), modulus of rupture( MOR) and modulus of elasticity( MOE) of GPB. 研究表明,添加适量的有机硅防水剂能提高石膏刨花板的防水性能,并对板的内结合强度、曲强度和弹性模量有一定的改进。
- Bond strength is an important parameter for wafer bond. 键合强度是关系到键合好坏的一个重要参数。
- The bonding strength of vapor deposited hard films are measured by this meth... 但人们在膜基结合的测试技术上仍有困难。
- The bond strength experiment of dogtooth exposed to pulsed Nd: YAG laser[J]. 引用该论文 朱建中;黄炜;许肖杰;林斌;陈钰清;顾锡荣.
- Xeno III Adhesive provides bond strength comparable to total etch systems. 异种三胶粘剂粘结强度可比提供总额蚀刻系统。
- Alkali soaking increased fiber swelling, reduced internal bonding, enhanced the pliability of the fibers, as well as increased the potential bonding areas between fibers. 3.;碱浸渍处理使纤维膨润性增大,纤维内聚力降低,增加纤维的柔软性,且增加纤维与纤维间之结合面积,而达到改善纸力之目的。
- Indirect methods to measure the interface bond strength include the interlaminar shear strength test. 测量界面粘结强度的间接方法包括层间剪切强度试验。
- Glue Hard brittle brownish solid made by boiling hides and bones.Dissolves in hot water with good bonding strength. 通过煮沸处理动物皮和骨骼而获得的硬而脆的褐色固体。它溶于热水并具有良好的粘合性能。
- The ARB technique not only increased greatly the bonding strength of TA1/Q235 clad plate,but also thinned the microstructure of Q235 plate. 结果表明采用累积叠轧焊方法不仅可以大幅度地提高TA1/Q235的结合强度,而且还可以获得连续均匀、组织细化的Q235的结合组织。
- Glue: Hard brittle brownish solid made by boiling hides and bones.Dissolves in hot water with good bonding strength. 动物胶:通过煮沸处理动物皮和骨骼而获得的硬而脆的褐色固体。它溶于热水并具有良好的粘合性能。
- Finally, the bond strength of FRP bars to epoxy resin and cement grout is also studied. 同时对纤维塑料筋与水泥装和环氧树脂的粘结强度也进行了探讨。
- This paper analysed the influence of specimen thickness on test results of surface bonding strength of thin MDF. 分析比较薄型中密度纤维板试件在检测时组合厚度的改变对其表面结合强度测试结果的影响。
- Crossbands shall be edge-glued or one piece wood or high performance composite product with an internal bond of atleast 200 psi (ASTM D 1037), without voids or show-through(telegraphing). [[交叉板,木制品行业用语,在制作木门中采用的板材,目的是增强门页的强度。美国的AWI标准中有规范。