您要查找的是不是：
- junction box assembly 接线盒
- Height Floor to Junction Box mm. 高度接线盒高度。
- Screw the standard rail up in the junction box. 将标准导轨用螺钉紧固在接线盒上；
- It is same to TC & RTD products，otherwise the junction box have some change. 除接线盒结构有改动外，其它与热电偶或热电阻产品一样。
- All dies should have a quick disconnect junction box for easy hook up to the die protection control. 所有的模具应该有一个很容易连接模具保护装置的快速切断盒。
- CZ-JB junction box produced with Bao Steel A3 material with painting after surface finish. JB接线箱采用宝钢产A3板材进行加工生产，表面加工处理后喷漆。
- CZ-JB junction box is produced with Bao Steel A3 material with surface finish of paining and plastic spray. JB接线箱采用宝钢产A3板材进行加工生产，表面处理烤漆、喷塑。
- Remove junction box cover that is secured by 3 screws. Place the cover aside and view the wiring diagram on the inside. 通过旋下3个螺丝来拆卸接线盒。把盖子放在旁边并察看内面的接线图。
- AH seriesflame-proof junction box code, outline and descriptions as the following table. 系列隔爆型接线盒代号,外形及名称一览表。
- He's buried something in a junction box out there and covered it with dirt-- I saw him. 他在外面的接线盒里埋了些东西然后用土盖住我都看见了。
- Loosen the screw holding the junction box cover to the top of the water heater. Set the cover aside. 卸下热水器顶部接线盒盖上的固定螺丝。把盖子放在旁边。
- Where there is distortion,crack or damage on the junction box,it must be stopped using. 发现接线盒外壳有变形、裂痕和损坏、应停止使用。
- The unit shall be equipped with an external, top located electrical junction box. 这种热水器应该配置一个外置的，位于上部的电气接线盒。
- A standard 1/2 inch opening has been made in the junction box for conduit connections. 作为标准配置，在接线盒上有一个1/2英寸的开口，用于导管连接。
- Load Cell Junction Box Protection Module: Protects load cells from surge induced in indicator Cable. 传感器接线盒保护装置：防止仪表电缆的感应浪涌电压损坏传感器；
- The junction box, standard with replacement motors, encloses the terminals and provides knockouts for wiring conduits. 此接线箱为替换电机的标准配置，具有封装接线端和集线作用。
- Ground the water heater by connecting the grounding wire from the electrical service ground to the (green ) ground screw located in the junction box. 热水器的接地通过从电气装置上将接地线连接到位于接线盒上的（绿色）接地螺丝上实现。
- Please open the cover of junction box on themotor could you switch on and start the motor on the MSB afterclose the cover? 请打开电动机接线盒盖盖上盖子在主配电板上合上开关并启动电动机？
- CZ-JB junction box is intended for indoor or outdoor use as electrical junction box, terminal wiring box, and instruments housings. JB接线箱，是用于室内和室外的电气接线箱、终端连接箱、和仪表箱。
- The motor is made of fan-cooled struction of steel plate.The Junction box is made of high intersity sturaction of costion. 电动机采用自扇冷式钢板结构，接线盒为高强度铸铁结构。
