您要查找的是不是：
- This paper provides that partial open sound insulating cover is adopted to insulate against sound and decrease noise of large air compressor unit. 介绍了采用局部敞开式隔声罩隔音降噪技术治理空分站大型空压机组噪声的治理方案及取得的效果。
- large air compressor unit 大型空压机组
- This paper gives an example describing the trouble shooting of oil whipping in a large air compressor by the use of vibration spectral analysis. 摘要本文给出了用振动谱分析方法对一种大型空气压缩机油膜自激振荡进行故障诊断的实例。
- The fracture of an axle pin in a large air compressor was analyzed by fractography, metallogra-phy, stress analysis.The results showed that fracture of axle pin was caused by improper heat treatment. 采用断口分析、金相检验及受力分析等方法;从微观机理及宏观力学两方面分析了轴销断裂的原因;并建立力学模型考察其疲劳强度.;试验结果表明;造成轴销断裂的主要原因是热处理工艺控制不当
- Large air and navel forces were set into action. 庞大的空军和海军部队开始行动了。
- Implementing Economic Running of Air Compressor Unit by Supplying High Pressure Air 利用高压向低压自动补气实现空压机组经济运行
- The air compressor washer to be confirmed. 空压机垫片提交。
- The alignment of air compressor to be confirmed. 空压机找中提交。
- The Application of Vibration Probe in Large Air Compressors 振动探头在大型空压机组中的应用
- Shanghai Xiangyang Air Compressor Co., Ltd. 上海向杨空压机有限公司。
- Compressor unit fully isolated from mechanical vibration. 整机无机械震动传递,完全隔震。
- Large air and naval forces were put into action. 出动了庞大的空军和海军力量。
- Large air and naval forles were put into action. 出动了庞大的空军和海军力量。
- large air compressor 大型空气压缩机
- Here is our pipe prefabrication workshop (steel structure fabrication shop, machine shop, boiler room, air compressor station, concrete mixing unit). 这里是我们的管道预制车间（钢结构制作厂、机械加工车间、锅炉房、空气压缩机站、混凝土搅拌装置）。
- Carry out inspection, repair and test of air compressor. 空压级机的检查、维修和测试。
- Warning - Do Not Use For Reciprocating Air Compressor Service. 警告:不要用在往复式空气压缩机管线上。
- Huizhou Biaoding Air Compressor Technology Co., Ltd. 惠州市标顶空压技术有限公司。
- Valves are not to be used near a reciprocating air compressor. 阀门不能安装在往复式空气压缩机附近。
- Underneath the rear fuselage a large air scoop aspirated the second unit, which powered a three-bladed propeller mounted behind a cruciform tail. 在机身后部下设置有大型进气口用来吸收十字尾翼后面的三叶螺旋桨气流。
