您要查找的是不是：
- We are known professional company of Nd:YAG laser power supply. 的工作态度使得我们可以为客户量身设计各种特殊的激光电源。
- This is the starting point for the analysis of laser power output that follows. 这是下文用来分析激光输出功率的出发点。
- These applications require, at most, only a few watts of laser power. 这些应用所用的激光功率最多为几瓦。
- I laser power is the latest company superhigh pressure, high-frequency service, driven by the United States IR company-wide functional laser power. 激光电源是我公司最新研制的超高压、高频制式、采用美国德州仪器公司机芯的全功能激光电源。
- The expressions of the relations among laser power, scanning speed, and harden layer, peak temperature are obtained. 通过分析激光工艺与硬化层深度和表面峰值温度的关系，确定出激光功率和扫描速度对硬化层深度和表面峰值温度的经验关系表达式。
- The effect of laser power on the microstructure of the films was investigated by means of Raman spectrometer and HRTEM. 采用拉曼光谱仪和高分辨透射电镜对激光晶化薄膜的组织结构进行了研究。
- The results showed that increasing scan rate and decreasing laser power can minish balling effect to a certain extent. 研究表明，适当提高扫描速度或减小激光功率可以在一定程度上减小316不锈钢粉末激光烧结的球化效应。
- Transverse misalignment excitated a lot of screw rays,which can make the output laser power distribution more uniform. 横向偏移激发大量斜光线产生,使光纤输出激光能量分布匀化；
- The results show that increasing scan rate and decreasing laser power can minish balling effect to a certain extent. 研究表明,适当提高扫描速度或减小激光功率可以在一定程度上减小316不锈钢粉末选择性激光烧结的球化效应。
- Parameters such as laser power, beam scanning speed and so on had fairsized effec... 激光功率和光束扫描速度等参数对固化过程有较大的影响;
- The depth and width of quenching layer increases with the laser power increasing. 激光输出功率增大,淬硬层深度和宽度增加。
- The maximal ratio of hybrid/MAG weld penetration is 1.5 and the lowest YAG laser power that augments MAG arc is 73 W. 复合与MAG焊缝熔深比最大达1.;5，YAG激光增强MAG电弧的最小激光功率为73 W；
- The perfected circuit can inspect and adjust the laser power so that VCSEL can keep unvarying power output. 经过完善的电路设计可以实现芯片对激光器发射功率的监控和调整以及适当的温度补偿。
- Violet laser power 5a MW, 30 MW, for silver halide photopolymerization plates and plates. 紫激平器的功率有5毫瓦、30毫瓦，不合别合用于银盐版材和平撮合版材。
- Laser power index in multiphoton processes is discussed in detail for the simple three-level system. 本文详细地讨论了三能级系统多光子过程的光强指数。
- At the risk of oversimplification we present an argument that predicts the proper dependence of the average laser power. 我们冒着过于简单化的风险而提出一种论点，这种论点能预示出激光功率的适当的内在联系。
- A multilevel laser power modulation method was developed based on the industry standard architecture (ISA) interface and a complex programmable logic device (CPLD). 该文描述了一种基于工业标准结构(ISA)总线和复杂可编程逻辑器件(CPLD)的多阶激光功率调制方法。
- When laser power density is greater than 18 GW/cm~2,residual stresses of EBW line are changed,which improves residual stress distribution. 当激光冲击的功率密度大于18 GW/cm2时,激光冲击强化处理使电子束焊缝区的残余应力改变明显,改善了焊缝残余应力的分布;
- Photoluminescence intensity changes as the function of laser power,and the maximum peak at 412 nm presents blue emission. 不同激光功率下沉积ZnO纳米薄膜经500℃热处理后的PL峰,其强度随激光能量而变化,最大发光波长位于412nm。
- High controlled capability of the superconducting switch can be obtained because of the more homogeneous laser power density. 因光束光强分布更加均匀，使通断控制性能更高；
