您要查找的是不是：
- load control protocol 负控规约
- The PPP link control protocol terminated. PPP链接控制协议已终止。
- This is a load control forms of code. 这是一个控制窗体加载的代码.;-
- The remote computer terminated the control protocol. 远程计算机终止了控制协议。
- It is a control protocol for multimedia streaming over IP networks. 它是在IP网络上传输多媒体流的控制协议。
- Line |1: All controls must precede menus; cannot load control |2. 行 |1：所有的控件都必须优先于菜单；无法加载控件 |2 。
- Datagram congestion control protocol(DCCP)is a new transport protocol put forward by IETF. 数据报拥塞控制协议(DCCP)是IETF提出的一种新的传输层协议。
- The PPP control protocol for this network protocol is not available on the server. 在该服务器上PPP控制协议对于整个网络协议是不可用的。
- No PPP control protocols configured. 没有PPP控制协议被配置。
- The RTP media channels will still use Transmission Control Protocol (TCP), which is not encrypted. RTP媒体通道将仍然使用不加密的传输控制协议(TCP)。
- A control system includes an electrical load control device responsive to radiant energy and a transmitter. 一种控制系统包括一响应于辐射能的电力负载控制器件及一发射机。
- However, the media channels that use RTP will still use Transmission Control Protocol (TCP), which is unsecured. 但是,使用RTP的媒体通道仍将使用传输控制协议(TCP),而后者是不安全的。
- Elster Metering's products include electricity, water and energy meters, metering systems, and load control solutions. 埃尔斯特集团公司产品包括电表、水表、能量表、表计系统和负荷控制。
- Specifies the control protocol used in establishing a serial port communication for a SerialPort object. 指定为SerialPort对象建立串行端口通信时使用的控制协议。
- The load control device resides on a digital communications link and receives infrared commands via a lightpipe. 该负载控制设备驻留在数字通信链路上，并且经由灯管接收红外命令。
- Specifies the control protocol used in establishing a serial port communication for a. 对象建立串行端口通信时使用的控制协议。
- Real-time Transport Control Protocol (RTCP) is a sister protocol of the Real-time Transport Protocol (RTP). 实时传输控制协议(Real-time Transport Control Protocol或RTP Control Protocol或简写RTCP)是实时传输协议(RTP)的一个姐妹协议。
- Electricity metering equipment (a. C.) - General requirements, tests and test conditions - Part 21: Tariff and load control equipment. 电量测量设备(交流)。一般要求、试验和试验条件。第21部分:资费和负荷控制设备。
- PPP uses Link Control Protocol (LCP) to negotiate and setup control options on the WAN data link. 在广域网路资料连结上，点对点协定使用连结控制协定（LCP）沟通与建立的控制选项。
- All of the above will be a basis for the studies of flow load control, power supply recovery and damage loss mitigation of power system after earthquake. 该工作可为震后电力系统负荷快速调整、震区供电系统较快恢复电力供应，减少供电工程系统的损失提供理论分析依据。
