您要查找的是不是:
- manual adjusting knob 手调旋钮
- The regulating handle is fitted with a fine speed adjust knob and a latch. 调节手柄配有一个细的速度调整旋扭一个锁销。
- The volume adjustment knob on my TV is broken. 我电视机上的音量调节开关坏了。
- To clean strainer or replace seat/stem module shut off supply, loosen knob retaining screw and back off adjusting knob. 要清洗过滤器或更换阀座/阀杆模块,先关闭供应管道,松开旋钮固定螺丝并且将调节旋钮退出。
- Automatic or manual adjustment of Cfast and Cslow. 自动或手动调节快电容和慢电容补偿。
- The frequency used in experiments was set at 20.3 kHz (controlled through the adjusting knob). 频率被使用在实验被设置了在20.;3 千赫(被控制通过调整的瘤) 。
- Always depressurize a regulator before closing the adjusting knob and removing the regulator from the cylinder. 在关闭调整钮和从钢瓶上断开调整器之前,总是使调整器减压。
- Owner's Manual Adjusting Brightness Switching the Video Image From Your Computer Display To a Projector ... 拥有者手册 调节亮度 将视讯影像从您的电脑显示幕切换到放映机...
- Close the regulator. After relieving all the gas pressure, turn the adjusting knob counter clockwise as far as it will go. 关闭调整器。在释放了所有的气体压力之后,逆时针旋死控制钮。
- Manual adjustment mold height system, precision 0.1mm. 手动式模高调整;精度0.;1。
- Close the regulator. To close the regulator, turn the adjusting knob to the full counter-clockwise position. The regulator must be closed before opening the cylinder valve. 关闭调整器。要关闭调整器,把调整钮逆时针旋死。在开启钢瓶阀门之前,必须关闭调整器。
- DSP motive auto focus system and can match with manual adjustment. 动态自动聚焦系统,配合手动聚焦调整;
- For slower rebound, turn the red adjuster knob clockwise. 顺时针转动红色调节钮以减慢回弹速度。
- Turn the adjusting knob clockwise and establish the required use pressure by referring to the low-pressure gauge. Make sure that the cylinder valve is easily accessible. 顺时针旋转调整钮,通过查看低压量表建立要求的使用压力。确认钢瓶阀门容易接近。
- Check diaphragm regulators for creep (leakage of gas from the high-pressure to the low-pressure side when the adjusting knob is turned fully counterclockwise). 检查隔膜调整器是否有漂移(如果调整钮逆时针方向旋死的话,会出现从高压端到低压端的气体泄漏)。
- Never exchange the discharge (low-pressure) gauge for one of lower pressure. The gauge may rupture if the adjusting knob is unintentionally turned too far. 禁止把排出量表换成更低压力的量表。如果无意中把调整钮旋的太远的话,量表会破裂。
- A support class is provided, but it will require some manual adjustment. 虽然提供了一个支持类,但它要求进行某些手动调整。
- Back damper for registering position of board width is manual adjustment. 定位纸宽的后挡板手动式调整。
- Therefore, you do not have to manually adjust this setting. 因此,不必手动调整此设置。
- The user will not be able to manually adjust the column width. 用户将不能手动调整列宽度。