您要查找的是不是:
- thermistor maximum operating current>actual circuit operating current in the powel loop. 热敏电阻器的最大工作电流>实际回路的工作电流。
- Ratio of peak lamp current to RMS or average lamp operating current. 灯电流峰值与RMS(均方根值)或平均工作电流的比值。
- To travel at a constant speed,or at a speed providing maximum operating efficiency for a sustained period. 以经济速度行驶以稳定的速度行进,或在一段时间内以发动机效率最高的速度行驶
- Service conditions-line media, temperature, and maximum operating differential pressure. 应用环境-管路流体介质,温度和最大工作压差。
- The maximum operating temperature is directly related to the heat treatment process used in manufacturing components. 最高工作温度与制造元件所用的热处理工艺直接有关。
- To travel at a constant speed, or at a speed providing maximum operating efficiency for a sustained period. 以经济速度行驶以稳定的速度行进,或在一段时间内以发动机效率最高的速度行驶
- The company will also offer virtualization in order to save power and push systems to maximum operating capacity. 该公司也将提供虚拟化,以节省电源和推进系统,以最高的经营能力。
- Thus C1 must be large enough to supply operating current to the load without discharging moue than a few millivolts. 这样C1容量必须很大才能保证C1为负荷提供运行电流而放电量不超过几毫伏。
- Maximum operating torque that the operating shaft (operating knob) can endure in its full CW or CCW position. 动触点调节到触及终端止档时,无变形和其他可见损伤时的最大力矩。
- Four-chip versions produce 280 lumens with a lens and 200 lumens without a lens, in each case at an operating current of 700 mA and an output of 10W. 和没有一个透镜的一个透镜和 200个流明的四枚薄片的版本生产品 280个流明,在每个情况以一个操作 700个妈的涌流和操作 10 W 的输出。
- They recommend operating speeds or a maximum operating speed for that blade and print this information directly on the blade. 他们建议,最高运行速度还是运行速度,这一信息直接打印叶片叶片。
- When conductance heat is equal to half of Joule heat, the thermal flux at joint of binary current leads is minimum at large operating current. 认为大电流运行下,传导热等于焦耳热的一半时,在二元电流连接点的热流最小。
- The coefficient of grounding is the ratio of the maximum sustained line-to-ground voltage during faults to the maximum operating line-to-line voltage. 接地系数是故障时最大持续相电压与最大运行线电压之比。
- Likewise , C1 must have a large capacitance value is order to provide operating current for the load when D1 and D2 are not conducting. 同样,C1容量必须足够大,才可以保证在D1和D2不导通期间为负载提供运行电流。如果C1容量太小。
- This is the maximum continuous sinusoidal rms voltage, which maybe applied at any temperature upto the maximum operating temperature of the device. 在规定的环境条件下,保证压敏电阻器正常工作所允许连续施加的最大交流电压值。
- The extinction ratio changes with the operation current and temperature. 消光比随注入电流和温度的升高而变化。
- The divider exhibits a maximum operating frequency up to 16 GHz,and has an operating region of(5.8 GHz) under-10 dBm input signal. 该分频器最高工作频率达到16 GH z。 当单端输入信号为-10 dBm时;具有5.;8 GH z的工作范围。
- ANSI B16.18 states that the maximum operating pressure of 50-50 solder connections is 200 psi at 100oF, and decreases with higher temperatures. ANSI(美国国家标准化组织)B16.;18规定50-50焊料连接的最大工作压力在37oC下是200psi,温度越高,则压力就越低。
- It is well established that facet damage is caused by the optical flux density at the laser facet and that it is not a function of the operating current. 业已明确肯定,端面损伤是由激光器端面的光流密度引起的,并且不是工作电流的函数。
- The transistor with the breakdown voltage more than200V,the operating current more than 2A,the overcurrent protection by oneself lass than 4A hasbeen fabricated. 正常工作电源大于2A; 自动保护过电流小于4A的器件。