您要查找的是不是：
- maximum standard deviation 最大标准差
- The square of the standard deviation. 方差标准偏差数的平方
- SD: Standard deviation of the fit. 拟合的标准偏差。
- Items used to determine the standard deviation. 用于确定标准偏差的项。
- The maximum of standard deviation of its total acid radical content is 0.04mmol/g. its varying coefficient is 0.80%. 该方法重复性好;其总酸性基测定的最大标准偏差为0.;04mmol/g;变动系数为0
- Because the Age field evaluates to a number, it supports the Sum, Average, Count, Maximum, Minimum, Standard Deviation and Variance functions. 由于“年龄”字段的计算结果为数字,因此该字段支持“合计”、“平均值”、“计数”、“最大值”、“最小值”、“标准偏差”和“方差”等函数。
- The first thing I did with this data was to calculate the average, minimum, maximum, and standard deviation of hours spent on each of twelve assignments. 我对这资料做的第一件事是计算十二个作业中的每一个所花费的时间的平均值、最小值、极大值和标准差。
- A volatile stock would have a high standard deviation. 不稳定的股票会有一个高的标准离差。
- The standard deviation from the mean is the preferred quantity. 用平均值得出标准偏差是优先采用衡量的单位。
- Count, mean, median, minimum, maximum, range, variance, standard deviation, standard error, coefficient of variation, skew, kurtosis and frequencies are supported. 计数，平均值，中位数，最低，最高，范围，方差，标准差，标准差，变异系数，斜，峭度和频率的支持。
- The results: The first thing I did with this data was to calculate the average, minimum, maximum, and standard deviation of hours spent on each of twelve assignments. 结果是：+我对这资料做的第一件事是计算十二个作业中的每一个所用时数的平均值、最小值、极大值和标准差。
- Items used to determine the population standard deviation. 用于确定总体标准偏差的项。
- Retrieves the standard deviation value for a specified column. 检索指定列的标准偏差值。
- Average angle and standard deviation also available. 平均值和标准背离值同样是被用到的。
- We porpuse to inport 500000 pieces of E27 ceramic Lamp holder with maximum standard approvals. 本信息价值3点积分,建议回复日期2007-06-03之前,还可被浏览20次
- Returns the predicted standard deviation for the specified column. 返回指定列的预测标准偏差。
- The rel-ative standard deviation were Br- 2. 0%, I- 1. 5%. RSD：Br－2.;0%25I-1
- The relative standard deviation should be no greater than 2.0%. 其相对标准偏差也应不大于2.;0%25。
- Standard deviation, RSD and confidential limit should be reported. 均应报告标准偏差、相对标准偏差和可信限。
- The spacings at fuses and fuseholders shall be measured with the fuses in place and removed. The fuses shall be those with the maximum standard dimensions. 保险丝和保险盒之间的间隙应当在保险丝装上和未装上时分别进行测量。保险丝应为符合标准的最大规格丝。
