您要查找的是不是：
- An instrument for measuring voltage. 静电计测量电压的仪器
- A voltammeter is a device for measuring voltage or amperage. 伏安计是用于测量电压和安培数的仪器。
- The unit we use to measure voltage is the volt. 计量电压的单位是伏特。
- I.R. measuring voltage is equal to rated voltage accord with customer requirement. 注2：I.;R
- Secondly, an optic-electric measuring system for measuring voltage distribution of MOA is developed in this thesis. 其次，本文研制了一套可用来测量MOA电位分布的光纤测量系统。
- Leakage paths can cause error by reducing the measured voltage. 漏泄通路会降低测得的电压，从而引起误差。
- Switching and measuring voltage sources with high internal impedance are subject to a number of errors, including offset currents, stray leakage paths, and electrostatic interference. 切换和测量具有高内阻的电压源会受各种误差的影响，包括偏移电流、寄生漏泄通路，以及静电干扰。
- Electrometers can measure high resistance either by sourcing current and measuring voltage or by sourcing voltage and measuring current. 静电计能够测量高值电阻，其方法可以采用加电流测电压，也可以采用加电压测电流。
- Experimental results show that the optic-electric measurement system can meet the requirement of measuring voltage distribution of valve thyristors. 实验表明本文研制的光电测量系统可以满足测量换流阀晶闸管电压分布的需要。
- The digital display meters are used in measuring voltage of AC, DC, direct current, power, power factor, rotational speed, voyage, petroleum power system, railway, military and so on. 广泛应用在航天、航空、石油、电力、铁路、军工等各个领域，用户遍及全国各地二十多个省市，部分产品已远销澳洲、北美洲。
- The SMU provides four functions in one instrument: measure voltage, measure current, source voltage and source current. SMU在一台仪器中提供四种功能：电压测量、电流测量、电压源和电流源。
- The signal source is represented by VS andRS, the shuntcapacitance isCSHUNT, and the measured voltage is VM. 电压源由VS和RS来表示，分流电容为CSHUNT,测量的电压为VM。
- Any external shunt resistance across the voltage source will attenuate the measured voltage, as shown in Figure 2-3. 跨接在电压源上的任何外部分流电阻都会使测量的电压衰减，如图2-3所示。
- These should be rated slightly higher than the SMU's maximum measurable voltage. 其额定电压应当比SMU的最大可测量电压略高一些。
- Another consideration when measuring voltages from high resistance sources is the input bias current of the voltmeter. 在测量高电阻源时要考虑的另一个问题是电压表的输入偏置电流。
- Calculating the average value of measured voltage and introducing the policy of multi-sensor interfusion could increase the reliability. 通过求其两线圈测得电压的平均值,并引入多传感器融合策略,则可增加整个电机运行过程中的可靠性。
- Generally, such instruments can simultaneously source voltage and measure current or simultaneously source current and measure voltage. 一般地说，这种仪器能够同时输出电压、测量电流以或者同时输出电流、测量电压。
- The thrust of propeller was tested using Hooke s law.Interpolating method was further applied to find the rotational speed of the motor and the thrust under a measured voltage. 中文摘要目前各国所发展的水下载具，主要用途是作海底资源探测或海上灾难救援等任务，其尺寸仍以中大型为主。
- Residual capacitor voltage can be measured with a source-measure unit (SMU), which must source voltage and then measure voltage with a high input impedance. 电容器上的剩余电压可以用一台源-测量单元（SMU）来测量。此设备必须能够输出电压，然后再以高输入阻抗来测量电压。
- If the applied and induced currents head the same way, they will add up to exceed the system's threshold for superconductivity, creating a measurable voltage. 如果外加电流与感应电流同向，它们就会因加乘而超过系统超导的阈值，从而产生可测得的电压。
