您要查找的是不是：
- Audiophile-grade metal film capacitors. 古典音乐级金属化薄膜电容器。
- THE MEDIUM-RELATED SURFACE OPTICAL PROPERTIES OF NOBLE METAL FILMS? 贵金属薄膜与介质相关的表面光学特性研究?
- Chapter Two devotes to study the epitaxial growth of ultra-thin metal films. 第三章：用动力学蒙特卡罗模拟研究表面剂诱导外延中二维岛的形成。
- The right photo shows the result with obliteration of most of the CD metallic film without charring. 有权图示结果与擦掉大部分的镉金属膜无炭化。
- We can classify thin films into four groups:thermal oxides,dielectric layers,polycrystalline silicon, and metal films. 我们可以把薄膜分成四组：热氧化物，介电质层，多晶硅，金属薄膜。
- AntiReflection coating. A thin, dielectric or metallic film applied to an optical fiber surface to reduce its reflection and thereby increase its transmitting ability. 抗反光涂层。一种薄的绝缘体或金属薄膜（或者是类似薄膜），贴在光纤表面以减少反射，并以此而提高光纤的发射能力。
- Abstract: The testing principle of the magnetoresistive effect of metal films by the probe-method was introduced. 文章摘要: 概述了探针法金属薄膜磁电阻效应测试的原理;
- SIMS analysis showed that there exist ion exchange between Cu and Ag, which is different from the clear interface between Cu and Ag in the metal films. 结果表明;不同于纯金属薄膜中Cu、Ag清晰的界面;在络合物中的Cu与Ag之间存在交叉;说明两种离子之间存在着交换现象.
- Moreover, by depositing metal films on the AAO substrates, we proposed a new method to fabricate surface plasmonic crystal. 此外，通过在规则排列的氧化铝膜上蒸镀金属，我们得到了一种新型表面等离激元晶体。
- While the commonly used resistors are RT carbon film resistor, RJ metal film resistor and RX winding resistor. 而固定电阻常用、常见的有RT型碳膜电阻、RJ型金属膜电阻、RX型线绕电阻。
- The adhersion between metal film and the PI substrate was good enough to pass the “transparent tape test”. 该实验将激光技术与电镀这一传统工艺相结合，从而提高了有机复合薄膜的电导率。
- Metal films exhibiting either perforated hole-arrays or corrugated structures with various surface morphologies can be fabricated rapidly. 利用奈米直印金属技术制作出的周期性金属薄膜结构，很适合用来研究表面电浆共振所引发的异常穿透现象。
- This paper proposes a motor protection scheme that a HV current transformers is replaced by fine metallic film resis tor strings, in order to reduce cost, volume and weight of protection device. 本文提出了采用精密金属膜电阻串取代高压电流互感器的电动机保护设计方案,以求减少保护装置的价格、积和重量。
- A special coating system wsa newly developed for metallic film resistors deposited through magnetron sputtering process, which was available to provide low, medium and high-resistance films. 摘要新型磁控溅射电阻镀膜机是在同一台设备上能制作出中、低和高阻值金属膜电阻的专用设备。
- H. T. G. Hentzell, C. R. M. Grovenor, and D. A. Smith, “Grain Structure Variation with Temperature for Evaporated Metal Films”, J. Vac. Sci. Technol., A2, 218-219 (1984). 汪裕闵，磁控溅镀氮化锆薄膜特性研究，硕士论文，国立成功大学材料科学研究所，(2001
- In the plasma spray rapid metal tooling, the wearable metal film with high hardness is formed on the sprayed prototype by robotic plasma spraying. 摘要在等离子喷涂快速制造金属模具工艺中，采用机器人等离子喷涂成形工艺，在被喷涂原型表面生成具有较高硬度的耐磨金属涂层。
- For the SPW sensor consisting of metal film and dielectric, surface plasmon vibration is essentially the vibration of group electrons. 对于金属／介质的表面等离子体波传感器，在界面处产生的等离子体振动实质是大量电子的集体振荡。
- The emery is a hard metallic substance. 金刚砂是非常坚硬的金属物质。
- Long-ranged surface plasmon modes on the interface between super-thin metallic filmand media were excited by using the angle-scanning ATR method, in which the thicknessof metallic film was thinner than 200A. 用角度扫描衰减全反射方法激励了厚度小于200A的超薄金属膜中的长程表面等离子激元模。
- The heat-isolating metal film was cut in strips to avoid vortex excitedby the primary field of TEM, and thus the influence of Dewar on measurements waseliminated. 采用具有迭层、独立单元的杜瓦绝热技术,避免绝热层金属薄膜在瞬变电磁一次场激发下产生涡流,消除杜瓦对测量的影响。
