您要查找的是不是：
- nil contact angle 无接触角
- The polymer film's hydrophile was test with contact angle machine. 利用接触角测试仪分析该聚合膜的亲水性。
- For hydrophilic materials, the contact angle will be lower than 90 degrees. 亲水性材料的接触角度会低于90度。
- Contact angles are of interest to ducks and swans. 接触角对鸭和天鹅是颇为重要的。
- An alternate experimental approach which does not require the direct measurement of contact angle appears to be promising. 有一种可选用的试验方法看来很有希望，它不要求直接测量接触角。
- An alternate experimedirect measurement of contact angle appears to be promising. 有一种可选用的试验方法，它不要求直接测量接触角，看来很有希望。
- Bearing with steep contact angle and intermediate ring, pierced rollers and pin-type steel cages. 带有大接触角以及中隔圈、穿孔滚子和钢支柱式保持架的轴承。
- Bearings having a large contact angle are a special design of the TDI configuration (fig 9). 有大接触角度的轴承是TDI配置的特殊设计(图9)。
- Bearing with large contact angle, intermediate ring between the outer rings and pressed steel cages (fig 9). 带有大接触角度、外圈之间的中隔圈和钢板冲压保持架的轴承(图9)。
- Bearing with steep contact angle, matched inner rings, injection moulded segment cages of polyamide 6,6. 大接触角轴承,配对内圈,注模尼龙6,6分段保持架。
- The time-dependent height,wetting radius and contact angle of the droplet were measured. 实验测量了液滴高度、湿润半径和接触角随时间的动态演化。
- Basom observed the contact angle of water against silane-treated E glass to be about 1. 2 rad. 巴索母观察到水对硅烷处理的E玻璃接触角大约是1.;2弧度。
- Though the linear regression equation,grafting yield of product can be counted directly by contact angle. 推导出的线性回归方程,能通过接触角的测定直接计算出接枝率。
- Our football team won by four goals to nil. 我们的足球队以四比零取胜。
- The existence of MPS is examined by thermogravimetric analysis and contact angle testing. 热重分析和接触角测试验证了粒子表面MPS的存在。
- As the content of BMA increases, the melting point, enthalpy of fusion, dynamic contact angle of copolymer rise. 梳形聚合物的熔点、焓值及静态接触角随着共聚物中BMA含量的升高而升高。
- In this case the water contact angle approaches zero and flow down when the surface leans. 如果玻璃非常平整及非常干净,水滴在玻璃上将自由展开,接触角为零。
- We can win the rubber 2 games to nil or 2-1. 我们可以以2比零或2比1赢得这三局两胜的比赛。
- Its contact angle, water absorption rate, motionless fric-tion coefficient and sliding time are respecivey tested. 对修饰后的材料表面进行接触角、吸水速率、静摩擦系数、滑动时间等指标测定。
- The plant was growing at an angle. 植物呈一定角度生长。
