您要查找的是不是：
- normal operating current 正常运转电流
- Keywords current distribution;LTS/HTS composite superconductors;normalized operating current; 电流分布;低温/高温复合超导体;归一化运行电流;
- This is the maximum current that can flow safely into an input terminal of the device at voltages above or below the normal operating range. 在器件电压高于或低于正常工作电压原范围内,可以安全地流入器件输入端的最大电流。
- The normal operating pressure value can also be achieved in summer. 正常工作压力值在夏季也能达到。
- Determine that the yield is within the normal operating range. 确定收率是限定在通常的操作范围之内。
- Ratio of peak lamp current to RMS or average lamp operating current. 灯电流峰值与RMS（均方根值）或平均工作电流的比值。
- Methods should be applied under normal operating condition. 以上方法应在常规操作条件下使用。
- The voltages set up are of normal operating frequency. 由此引起的过电压频率通常为正常的工作频率。
- The current assets are cash and other assets that will be converted into cash or used up during the normal operating cycle of the business or one year, whichever is longer. 流动资产是现金以及将在企业的正常经营周期或一年（视何者较长）内变换为现金的或耗用的其他资产。
- Every normal operator is trivially subnormal. 每一个正规算子显而易见地是次正规的。
- Scientific and normal operation procedure. 科学规范作业程序。
- A: About 2% in normal operations. 正常情况下为2%25左右。
- Thus C1 must be large enough to supply operating current to the load without discharging moue than a few millivolts. 这样C1容量必须很大才能保证C1为负荷提供运行电流而放电量不超过几毫伏。
- NN.N -tension value during normal operation. 在正常的运算期间的张力数值。
- Maintain the store normal operation order. 维持店内的正常营业秩序.
- Four-chip versions produce 280 lumens with a lens and 200 lumens without a lens, in each case at an operating current of 700 mA and an output of 10W. 和没有一个透镜的一个透镜和 200个流明的四枚薄片的版本生产品 280个流明,在每个情况以一个操作 700个妈的涌流和操作 10 W 的输出。
- At normal operating voltage, the TVS diode is inactive, like an open circuit. 雪崩崩溃二极管是以反向电流的方式,连接在线路上。
- When conductance heat is equal to half of Joule heat, the thermal flux at joint of binary current leads is minimum at large operating current. 认为大电流运行下，传导热等于焦耳热的一半时，在二元电流连接点的热流最小。
- Likewise , C1 must have a large capacitance value is order to provide operating current for the load when D1 and D2 are not conducting. 同样，C1容量必须足够大，才可以保证在D1和D2不导通期间为负载提供运行电流。如果C1容量太小。
- The extinction ratio changes with the operation current and temperature. 消光比随注入电流和温度的升高而变化。
