您要查找的是不是:
- Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference. 在传动轴和传动轴轴轭、或小齿轮轴轭上作标记,作安装的参考标志。
- Using a short piece of pipe and Holder 6958 to hold the pinion yoke, or pinion flange, remove the pinion nut and washer. 用短管和托架6958固定小齿轮轴轭或小齿轮凸缘,拆下小齿轮螺帽和垫圈。
- propeller shaft pinion flange 传动轴主动齿轮凸缘
- rear axle bevel pinion flange 后桥主动伞齿轮法兰
- pinion flange 小齿轮突缘
- There is something wrong with this pinion; it doesn't move. 这个小齿轮有问题,不转了。
- Align mark on front universal joint, or CV joint, to the mark on the axle pinion yoke, or flange. 将前万向节或CV万向节上的标志与车轴小齿轮轴轭或凸缘上的标志对准。
- Only one set of flange studs is needed. 只需要一套法兰柱头螺栓。
- Refer to Drive Pinion Bearing Pre-Load Adjustment. 参阅驱动小齿轮轴承预荷调整。
- These include gusset plates welded to the flange. 这些包括焊接到翼缘上的节点板。
- Worn teeth on ring gear or drive pinion gear. 环形齿轮或驱动小齿轮上齿磨损。
- Using thread or flange capillary connection. 采用螺纹或法兰毛细管联接。
- Rotate the pinion yoke three or four times. 旋转小齿轮轴轭三次或四次。
- Press the flange and replace the side sealing ring. 压紧法兰(均匀用力)更换侧密封圈。
- Remove pinion gears from differential case. 从差速箱处拆卸主动齿轮。
- Install pinion front bearing, if necessary. 如需要,安装小齿轮前轴承。
- Install the pinion mate gears and thrust washers. 安装小齿轮配合齿轮和止推垫圈
- End play in drive pinion bearings. 驱动小齿轮轴承的端隙。
- Firmly press downward to seat seal on flange. 稳固地向下压将座椅密封压入凸缘中。
- To create the flange brand is our pursuing. 创法兰品牌是我们的追求。