该词条未找到_海词词典

您要查找的是不是：

The various types of stress, strain, and elastic modulus are summarized in Table 10-3. 各种应力、应变和弹性模量列于表10-3中。
The larger the elastic modulus, the greater the stress needed for a given strain. 弹性模量越大，产生一定应变所需要的应力也越大。
The ratio of stress to strain, or the stress per unit strain, is called an elastic modulus of the material. 应力与应变之比，即每单位应变的应力，叫做该材料的弹性模量。
Multiple tensions lowed down the elastic modulus of the alloy and exhibited a non-linear relationship with strain. 多次重复拉伸使其弹性模量降低并呈现非线性的变化趋势。
An analysis of the complex of viscoelastic country rock compled with viscoelastic (or elastic)lining in a circular drift under plane strain condition is given by this paper. 本文在平面应变条件下,对粘弹性圆形巷道和衬砌的耦合问题进行分析,衬砌(粘弹或弹性的)是在巷道开挖后,或巷道形成后经过一段时间蠕变才加上的。
With the increase of initial deviator stress, the dynamic elastic modulus increases greatly under the same level of dynamic strain. 在相同的动应变水平下，随着初始偏移应力的增加，土体动弹性模量有较大幅度的增加；
The compressive properties of saturated and dry concretes including strength, elastic modulus and peak strain under different loading rates are studied by experiments. 摘要在准静态及中低加载速率下，开展了饱和与干燥混凝土力学性能变化的试验研究。
The two cases of plane stress and plane strain will be discussed separately. 平面应力和平面应变这两种情况将分开讨论。
The static elastic modulus of the alloy is lower than 30 GPa. 合金的静态弹性模量小于30GPa;
The acoustic emissions and elastic strain energy decrease of rock specimens with initially random material imperfections in uniaxial plane strain compression were numerically modeled by using FLAC. 摘要利用拉格朗日元法(FLAC)模拟了单轴平面应变压缩条件下缺陷数目对含初始随机材料缺陷岩石试样声发射及弹性应变能降低的影响。
And the polymer is an all-organic composite,with a very high dielectric constant(>900) and high strain induced in a weak applied electric field (2% strain in 13MV/m) and the composite has an elastic modulus near 1GPa. 而全有机复合材料则呈现出十分高的介电系数(>900),和在13MV/m的较低电场下形成的2%25的高应变量及接近1GPa的高弹性模量。
In this paper, a method by the use of the stress-strain relations and the iterative calculation based on the finite element analysis was proposed to reconstruct the elastic modulus distribution from the axial strain distribution of tissues. 本文提出一种利用组织的应力－应变关系和基于有限元分析的迭代计算方法，从组织的纵向应变分布重建出组织的弹性模量分布。
There are two plane problems in the theory of elasticity, the problems of plane strain and of plane stress. 弹性理论中有两类平面问题，即平面应变和平面应力问题。
This paper introduces the treatment for deep dam foundation of the concrete cut off wall,which intensity and elastic modulus value are requirement to satisfy the stress,strain and durability. 本文介绍了砼防渗墙对土石坝深厚覆盖层地基的处理,强调防渗墙砼强度及弹模取值应在满足应力应变的前提下,兼顾耐久性等要求。
In the case of general anisotropy it is coupled with the ordinary plane strain problem. 在一般各向异性情况下，它与普通手面应变问题综合在一起了。
For the joints with low elastic modulus adhesives, both stress concentration degree at the weld spot and the shear strain at edges of overlap region are increased with the spot pitch increasing. 低弹性模量胶粘剂胶焊接头中，焊点处应力集中程度和搭接区边缘胶层中的剪应变值都随焊点间距的增加而增大，增加焊点间距，两种接头的胶层断裂强度都将降低。
Casing, cement and formation plane strain mechanical model are established, considering casing with initial ovality. 针对套管的不同初始椭圆度建立了套管、水泥环、地层平面应变力学模型。
The extrusion of compressible material in plane strain is analysed in use of UBET and compared to fully dense material. 应用上限元方法分析了可压缩材料平面应变挤压问题,并与致密材料进行了比较。
However, the elastic modulus of SCC is not significantly affected by S/A ratio when total aggregate volume is kept constant. 然而对弹性模数而言，当骨材总体积量一定时，改变混凝土含砂率对于弹性模数并没有太大的影响。
The relation of ??to the average value of ??may be assumed to lie between the aforementioned relations for uniform plane stress and uniform plane strain. 而?潞往闷骄?值的关系式可以认为处于上述的均匀平面应力和均匀平面应变的两个关系式之间。