您要查找的是不是：
- propeller shaft yoke 传动轴叉
- Install the straps and bolts to hold the propeller shaft to the yoke. 安装扣夹和螺栓，将传动轴固定到轴轭上。
- Align previously made marks on yoke and propeller shaft and install propeller shaft. 将定位轭架上的预制标记对准传动轴并安装传动轴。
- Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference. 在传动轴和传动轴轴轭、或小齿轮轴轭上作标记，作安装的参考标志。
- Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft. 对准传动轴和轭上安装参考标记，安装传递轴。
- Nothing seems to be wrong with the propeller shaft. 转动轴看来没毛病。
- Remove the universal joint strap bolts at the pinion shaft yoke. 在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
- Reindex propeller shaft 180° and evaluate. 将传动轴翻转180°，并测试。
- Remove the rear propeller shaft. 拆卸后传动轴。
- Aligning intermediate shaft and propeller shaft after launching. 下水后中间轴和螺旋桨连接后校中。
- This measurement will give you the propeller shaft angle (C). 测量结果就是传动轴工作角（c）。
- Measuring clearance between propeller shaft &bearing. 螺旋桨轴与轴承间隙测量。
- Different nacelle with deeper ross-section and intake over propeller shaft. 发动机舱、螺旋桨轴处的进气口有一些不同。
- The reason the propeller shaft shortens as the angle increases is that the rear axle and differential move in a shorter arc than the propeller shaft. 当角度增加时,传动轴变短的原因是后桥和差速器运动的弧度小于传动轴运动的弧度。
- This accommodates any effective change of length of the propeller shaft as the rear axles move toward or away from the car frame. 当后桥在车架上向前或向上运动时,这种结构足以调整传动轴长度的任何变化。
- The D9B can be equipped with a power take-off designed for propeller shaft operation or direct-mounted hydraulic pumps. D9B可提供适用于驱动轴运转或直接安装式液压泵的动力输出。
- The propeller shaft to be turned clockwise viewed from afterward of M/E when running ahead. 当主机正车时，从主机后面看螺旋桨轴为顺时针旋转。
- "The propeller shaft may be solid or hollow, protected by an outer tube or exposed. 传动轴可以是实心的或空心的,由套管加以保护或裸露在外。
- "The propeller shaft is a drive shaft to carry the power from the transmission to the rear-wheel axles. 传动轴是将动力从变速器传送到后桥的驱动轴上。
- The results show that it is successful to adopt the technolngy of cold drawing with core mandrel for processing the propeller shaft tube s... 试验结果表明,采用短芯棒冷拔工艺加工传动轴管,在技术上是成功的。
