您要查找的是不是：
- redundant signaling link 冗余信令链路
- Signaling Link Code = the member number within a link set. Signaling Link Code = 链路群内的成员号。
- Signaling Link Code--he member number within a link set. Signaling Link Code -- 链路群内的成员号。
- The CHG:SLK command is used to change the minor state of a signaling link. CHG:SLK 命令用于更改信令链路的次级状态。
- Major State of Link = the major equipage status of the signaling link. Major State of Link = 该信令链路的主要设备状态。
- The device routes or switches incoming messages to an outgoing signaling link using routing information within the multitiered SS7 message. 该装置为利用多层七号信令报文中的路由信息，为进来的报文送到输出的信令链路上建立路由或进行交换。
- This state Indicates that the AP-DS1 is available for use by an RCS signaling link. 该状态表明 AP-DS1 可供 RCS 信令链路使用。
- Direct-sequence spread spectrum (DSSS) takes a signal and "spreads" it over several frequencies, essentially creating redundant signals. 直接顺序扩频（DSSS）取出信号，把它“散布”到几个频率上，实质上形成了冗余的信号。
- Link Node Address (Group and Member) = the node within the IMS ring on which the signaling link terminates. 链路节点地址 (Group and Member) = IMS 环路内信令链路终止的节点。
- Signal unit initial alignment - invokes initial alignment prior to activating or restoring a signaling link. 信令单元初始定位 -- 在激活或恢复信令链路之前调用初始定位。
- Signaling links are usually equipped in pairs in SS7 networks. 信令链路常常是成对地装配在 SS7 网络中。
- Direct-sequence spread spectrum (DSSS) takes a signal and "spreads" it over several frequencies,essentially creating redundant signals. 直接顺序扩频（DSSS）取出信号，把它“散布”到几个频率上，实质上形成了冗余的信号。
- By this way, no redundant signals are added, and the bandwidth efficiency of OFDM system is further increased. 由于采用这种方法无需加入冗馀信息，故进一步提高了系统的传输效率。
- The s7ln form (SS7 link) is used to define the individual SS7 signaling links. s7ln 表(SS7 链路)是用于定义各 SS7 信令链路。
- Far-End CLLI = the Common Language Location Identifier (CLLI) that is associated with the STP or 5ESS DCS at the far end of this signaling link. Far-End CLLI = 与该信令链路远端处的 STP 或 5ESS DCS 相关的公用语言位置标识符 (CLLI)。
- Each signaling link may accommodate a traffic load of approximately 40 percent of its maximum load capacity. 每一信令链路可容纳其接近最大负载能力 40%25 的话务量。
- Major State of Link-this field contains the major equipage status of the signaling link. Major State of Link -- 该信令链路的主要设备状态。
- Far-End Point Code = the point code of the SS7 application at the far end of this signaling link. Far-End Point code = 该信令链路远端 SS7 应用程序的点编码。
- SS7 access link. A dedicated SS7 signaling link not physically associated with any particular link carrying traffic. SS7（7号信令）访问链路。SS7专用信令链路物理上不与任何特殊链路传输业务相关联。
- Both averaged transmitted-reference (ATR) modulation technique and forward error correction (FEC) coding technique can improve the performance of Ultra-wideband (UWB) autocorrelation receiver by adding some redundant signals. 平均发射参考(ATR)调制技术和前向纠错(FEC)编码技术都能通过增加冗余信号改善超宽带(UWB)自相关接收机的检测性能。
