您要查找的是不是:
- reset button imagev. [计]重置按钮图象
- There is no Name field for the reset button. 没有用于重设按钮的Name字段。
- Remove SD card. Push in the reset button. 移掉SD卡,软起即可。
- Immediately release the reset button. 立即松开复位按钮。
- Lightly press the RESET button with a thin rod. 用细杆轻按reset(重调)键
- Improved Added a layout reset button in thr. 在字幕布局编辑器中增加“重置所有设置”按钮。
- Press the reset button to turn off the alarm indicator. 按复位键关闭告警指示器。
- The Reset button clears the pattern so all files are displayed. “重置”按钮可清除模式以便显示所有文件。
- The toolbar control will extract the button image from this bitmap. 工具栏控件将从这个位图中展开这些按钮图片。
- Pre the reset button to turn off the alarm indicator. 按复位键关闭告警指示器。
- On the Tools menu, click Choose Toolbox Items, and select the Reset button. 在“工具”菜单上单击“选择工具箱项”,再选择“重置”按钮。
- Improved Added a layout reset button in the Subtitles layout editor. 在字幕布局编辑器中增加“重置所有设置”按钮。
- For a clear image, copy a graphic that is the same size as a built-in button image or a menu command image. 对于清晰的图像,将相同大小的图形复制为内置按钮图像或菜单命令图像。
- Retry this command until the mouse connects. You may have to turn it off and on or press the reset button a couple of times. 不断重试这个命令直到鼠标连接成功。你应当在一段时间内不断地关闭并打开鼠标或是按鼠标的重启按钮。
- An example of a composite control is a control that consists of a text box and a reset button. 其中的一个示例就是由文本框和重置按钮组成的控件。
- If, after pressing reset button, valve does not stay open allowing gas to flow to the burner, insufficient cooling of the water is the probable cause. 如果按下重置按钮后,阀门不能够停留在开启的位置让燃气流向燃烧头,可能就是因为水温降得还不够低造成的。
- To change a toolbar button image, copy the new button image, click Customize on the Tools menu, click the button with the right mouse button, and click Paste Button Image. 如果要改变按钮的图象,先复制所需的新图象,然后单击“工具”菜单中的“自定义”命令,用鼠标右键单击所要更改的按钮,再选择“粘贴按钮图符”命令。
- The high limit control can be reset by firmly pushing in the red reset button located on the thermostat. 高温限制控制可以重置,只需在温控器上的红色重置按钮上使劲按一下即可。
- HDD LED in Reset button (Orange LED) and Standby/Power LED in Power Button (Red LED). 硬盘驱动器的LED在复位按钮(橙色发光二极管)和备用信用证/功率LED在电源键(红色LED)。
- Failure reset: Incoming faults have to be acknowledged by pressing the “Failure reset” button on the visualisation. 出错后复位:出现的错误必需要按动面板上的“出错后复位”键来认可。