您要查找的是不是：
- After a specified “soak” period, energize Ch. 21 to measure the resulting current. 在规定的“保压”周期后，激励通道21，测量产生的电流。
- The resulting current is measured by the ammeter and the resistance is calculated using Ohm's Law (R= V/I). 由安培计测量产生的电流，再使用欧姆定律计算出电阻（R=V/I）。
- This will bias the X1 resistor and, after a specified “soak” time, the resulting current is measured. 这将为X1电阻器施加偏置电压，经过规定的“浸润”时间以后，测量所产生的电流。
- Isolation resistance measurements are usually made by sourcing a voltage, then measuring the resulting current using an electrometer or picoammeter. 在测量隔离电阻时，通常是提供一个电压，然后利用一个静电计或皮可安培计测量形成的电流。
- This technique for measuring high resistance involves sourcing a known voltage, measuring the resulting current, and calculating the resistance. 这种测量高阻的技术需要提供一个已知电压，测量产生的电流，然后再计算电阻。
- The voltage across RL1 is the picoammeter voltage burden, normally less than one millivolt, so the resulting current will be quite small. RL1上的电压为皮安计的输入端压降，通常小于1mV，所以产生的电流是相当小的。
- The resulting current is distributed through the volume of the test sample and is measured using a picoammeter or electrometer. 产生的电流将分布在测试样品的体内，并由皮安计或静电计来测量。
- The resulting current reference equals to the difference between the instantaneous current of nonlinear load and its fundamental positive sequence active component. 所求得的补偿电流指令为非线性负载电流中除了基波正序有功分量之外的全部电流分量。
- To make the measurement, a constant voltage is applied for a prede fined period, usually 60 seconds, and the resulting current is measured with a picoammeter or electrometer. 为了进行测量，在预定的时间（通常为60秒钟）内，给样品施加恒定的电压。然后，用皮安计或静电计测量产生的电流。
- It is measured by placing two electrodes on the surface of the test sample,applying a potential difference between them, and measuring the resulting current. 其测量方法是将两个电极放在测试样品的表面，在电极之间施加一个电位差，并测量产生的电流。
- We desperately need a result from this match. 这场比赛我们务必获胜。
- Loss of electric current as a result of faulty insulation. 漏电由于绝缘不好而导致的电流流失
- He is indifferent to the result of the exam. 他对考试结果漠不关心。
- What was the result of your deliberation? 你仔细考虑后结果如何？
- The ideal way to measure the resistance of an insulating material is to apply a known potential to the sample and measure the resulting current with an electrometer or picoammeter. 测量绝缘材料电阻的理想方法是向样品施加一个已知的电压，再使用静电计或皮安计测量产生的电流。
- The presumable result is an election defeat. 推测结果是竞选可能会失败。
- Don't prolong the agony just tell us the result! 别再让我们著急了--快告诉我们结果吧！
- No matter what she did, the result was all one. 无论她怎么做，结果都是一样的。
- However, this failed to produce the desired result. 但这并没有产生预期的效果。
- I felt nervous about the result. 我对该结果感到不安。
