您要查找的是不是：
- reverse cylinder valve stem 回动汽缸阀杆
- reverse cylinder valve body cap 回动汽缸阀体盖
- reverse cylinder valve arm 回动汽缸阀臂
- air cylinder valve stem 气筒阀杆
- The connecting rod may drive a valve stem directly. 连杆可以直接带动阀门的把柄。
- In a single-stage regulator, delivery pressure increases as cylinder pressure decays, because there is less gas pressure exerted on the valve stem. 在单级调整器里，输出压力随钢瓶压力的减小而增大，这是因为施加在阀门系统上的气体压力减小了。
- Taper screw thread for valve stem and cylinder neck assembly.Nominal diameter 16,4, taper 3/20, 14 TPI si. 气瓶.;气瓶阀门颈装配锥螺纹
- The double lift cylinder used here for control purposes permits the gas needle and the valve stem to be opened and closed separately. 为控制灌装过程,机器上安装了一个双冲程气缸,气针和阀锥的打开和关闭可以分开进行。
- In a single.stage regulator, delivery pressure increases as cylinder pressure decays, because there is less gas pressure exerted on the valve stem. 在单级调整器里，输出压力随钢瓶压力的减小而增大，这是因为施加在阀门系统上的气体压力减小了。
- Replaceable hose filter and valve stem seals for field reliability. 可更换软管过滤器和阀门阀杆密封,使得现场应用可靠行更高。
- The stove and cylinder valve's copulae, use tie-in double pressurize device. 卡炉与气瓶阀门的接合部位采用接头双重密封装置。
- For removal of valve stem seal and lower valve spring guide. 可用于拆卸汽门油封或降低汽门弹簧。
- Clean exposed portion of valve stem (Do not scratch). 清洗阀杆的外露部分(不要划伤)。
- A valve stem has broken off and effectively seized up the engine. 阀杆折断了，有效地阻止了发动机的运转。
- If user experiences any difficulty operating cylinder valve discontinue use and contact supplier. 如果使用者在操作气瓶阀时有困难,需停止使用,并与供应商联系。
- Valve stem 412 is dimensioned to attach to diaphragm 414, best seen in FIG. 2. 从图二可见，阀杆412设计成能与隔膜414接合。
- An acetylene cylinder valve should not be opened more than approximately1 1 /2 turns. 乙炔钢瓶阀门不能开启得超过大约11/2圈。
- Always pressurize a regulator slowly, while standing with the cylinder valve between you and the regulator. 总是站得使钢瓶阀门位于你和调整器之间，对调整器慢慢加压。
- Inspect for scuffed or bent valve stems. 检视气门杆是否擦伤或弯曲。
- Always open a cylinder valve slowly. Never crack open a hydrogen cylinder to clear the valve of dust, as the escaping hydrogen may ignite. 总是慢慢地开启钢瓶阀门。由于溢出的氢可能着火，禁止啪地一声打开氢钢瓶。
