您要查找的是不是：
- rock pressure sensor 矿压传感器
- E620018 "Air pressure sensor alarm. “发现气压下降。”
- E620057 "Air pressure sensor alarm. Ignore? “发现气压下降，是否忽略?”
- AK series mechanical strain pressure sensor. AK系列应变式压力变送器；
- This RNID doormat has a pressure sensor underneath. 这种RNID擦鞋垫的下面有一个压力传感器。
- Study of Pressure Sensor Based on Fiber Loop Ringdown[J]. 引用该论文 张卫华;刘波;罗建花;董孝义.
- As a standard the pressure sensor provides a standardized voltage output. 标准型压力传感器有标准的电压输出。
- Ultra-miniature Pressure Sensor Based on the Silicon Piezo-resistor Principle. 基于单晶硅的压阻效应的超小型压力传感器。
- P1195 EGR Pressure Sensor (1.6L) or Boost Sensor (1.8L) Open or Short. （EGR压力传感器（1.;6）或排气传感器（1
- The characters of deep mine are larger raw rock pressure,larger ore body plasticize,mine pressure severe appearance. 深矿井的特征是原岩压力大、矿体塑性大及矿山压力显现剧烈。
- The caving of thick and strong roof stratum,key stratum,causes tremendous rock pressure in mine. 采场上覆岩层中的厚硬岩层,即厚硬关键层,其冒落会造成剧烈的矿山压力显现。
- Accoording to the result on observation of rock pressure,adaptability of telescopiform bolt in soft rock road and reasonable structural parameter are analysed. 根据矿压观测结果分析了可拉伸锚杆对软岩巷道支护的适应性及其合理的结构参数。
- The combination of pressure sensor and special connection result in a better performance of the instrument. 采用特殊接口的压力传感器有更好的表现。
- On the basis of the observation to rock pressure,the strata behavior regularity of 93305workface is summarized,and the reason is analyzed,rome reasonable advices is put foreward. 在矿压观测的基础上，总结了该工作面的矿压显现规律，并对原因进行分析，最后就工作面的开采提出合理建议。
- The production is composed of DTZZIII-SK type elevator weight-load indicating controller box and pressure sensor. 产品由DTZZIII SK型电梯重量载荷指示控制仪和压力传感器两部分组成。
- Vacuum pressure: This window display vacuum pressure sensor gather actual pressure from entering air pipe. 本窗口中显示真空压力传感器在进气管采集到的实际的压力,它代表发动机的负荷。
- Fault Description(reason): High voltage detected at intake manifold pressure sensor signal pin. 故障描述（原因）：检测到进气歧管压力传感器信号电压值高。
- Pressure sensors OEM are top of the range pressure sensors. OEM压力传感器是传感器中的顶级产品。
- The piezoelectric pressure sensor, vacuum device and heating resistance are used in the experiment. 采用了压电式压力传感器、真空装置、加热电阻等实验设备。
- The inlet pressure sensor is fixed to a inlet pipe directly with a boltand prevent gas leak through two seals. 进气压力传感器是用一个螺栓直接固定到进气管上，并通过两个密封圈来防止漏气。
