您要查找的是不是：
- SLTM Signaling Link Test Message 信令链路测试报文
- SLTMA Signaling Link Test Message Acknowledgement 信令链路测试通报收到
- signaling link test message 信令锭测试消息
- SLTC Signaling Link Test Control 信令链路测试控制
- SLTA Signaling Link Test Act 信令链路测试作用
- signaling link test control 信令链测试控制
- data link test message 数据链路测验报文
- Signaling Link Code = the member number within a link set. Signaling Link Code = 链路群内的成员号。
- Signaling Link Code--he member number within a link set. Signaling Link Code -- 链路群内的成员号。
- The device routes or switches incoming messages to an outgoing signaling link using routing information within the multitiered SS7 message. 该装置为利用多层七号信令报文中的路由信息，为进来的报文送到输出的信令链路上建立路由或进行交换。
- The CHG:SLK command is used to change the minor state of a signaling link. CHG:SLK 命令用于更改信令链路的次级状态。
- Major State of Link = the major equipage status of the signaling link. Major State of Link = 该信令链路的主要设备状态。
- If no test message or delivery report arrives before this time expires, the task ends and an error is reported. 如果在该时间过期之前没有收到任何测试邮件或送达报告,则此任务结束并报告错误。
- Signaling links are usually equipped in pairs in SS7 networks. 信令链路常常是成对地装配在 SS7 网络中。
- One e-mail was a test message and the other was to John Glenn during a space shuttle commemorative flight. 克林顿所发的这两封电子邮件,一封是测试邮件,另一封是发给当时正在进行纪念性太空飞行的宇航员格林的。
- This state Indicates that the AP-DS1 is available for use by an RCS signaling link. 该状态表明 AP-DS1 可供 RCS 信令链路使用。
- Before you start the Telnet session, you must have the full SMTP e-mail address of the destination user who you want to send this test message to. 在启动Telnet会话之前,必须具有要将此测试邮件发送到的目标用户的完整SMTP电子邮件地址。
- Link Node Address (Group and Member) = the node within the IMS ring on which the signaling link terminates. 链路节点地址 (Group and Member) = IMS 环路内信令链路终止的节点。
- Connect to your organization's Edge Transport server from a host that is located outside your perimeter network and send a test message. 从位于外围网络之外的主机连接到组织的边缘传输服务器,并发送一封测试邮件。
- Signal unit initial alignment - invokes initial alignment prior to activating or restoring a signaling link. 信令单元初始定位 -- 在激活或恢复信令链路之前调用初始定位。
