您要查找的是不是：
- spindle locking screw 心轴锁止螺钉
- Loosen the height locking screw and remove the arm from the turntable. 放松高度螺丝，将唱臂自唱盘取下。
- Unload the wind window 4, loosen the lock screw of nut 5. 卸下通风窗4后;松掉锁紧螺母5上的锁紧螺钉.
- Replace the arm on the turntable and tighten the height locking screw sufficiently to hold the arm in position. 将唱臂重新装上，将高度螺丝锁到可让唱臂固定。
- The bottom view of the rifle, no locking screws. 自装枪的下方,无固定螺丝。
- Unscrew the carrier locking screw (item 2 in FIGURE 3-1) on the carrier handle (3. 鬆開托座把手上的托座鎖定螺絲(圖3-1中的項目2))。
- Install the pinion mate shaft lock screw finger tight to hold shaft during differential installation. 在差速器安装期间，安装小齿轮配合轴锁螺丝，用手紧固它，以把握住轴。
- The analytical results of femoral locking screw models were closely related to those of biomechanical tests with high correlation coefficient. 而生物力学实验与有限元素模拟有不错的相关系数，故可利用有限元素分析来准确预估生物力学测试结果。
- Using the wrench(es) provided, turn the collet nut (J) clockwise while holding the spindle shaft with the second wrench. [On the DW618, depress the spindle lock button (I) to hold the spindle shaft. 按住轴锁按钮（I），转动夹头直到轴锁锁住轴杆，这是用随机所带的扳手顺时针拧紧夹头螺母即可。
- It is a special project to a permanent adhesive resin in the thread, have always solid, permanent use, absolute lock screw environmental products. 它是将特殊的工程树脂永久地粘附在螺牙上，产生永远牢固、永久使用、绝对环保的防松螺丝产品。
- In the following section, we review four mechanisms of locked plate failures: (1) plate bending; (2) plate fracture; (3)plate pull-off; and (4) locking screw failure. 在一下部分，我们将回顾锁定钢板失败的四种机制：（1）钢板弯曲（2）钢板断裂（3）钢板脱出（4）锁定螺钉固定失败。
- X-ray evaluation demonstrated failure of the distal 2 locking screws with the heads sheared off (Figure 4). 线片现实内固定失败，远端2枚锁定螺钉在剪力下于螺钉头处折断（图4）。
- Stop Adjustment Screws as well as Locking Screws located in Body Adapter. This is external to Actuator Air Pressure Chamber. 止动调节螺丝也就是锁定螺丝,位于主体接头上。这是执行机构气源压力墙外的外部装置。
- I can't get this screw to come out of the wall. 我无法把这颗螺丝钉从墙上取出。
- Spindle is the measure for yarn. 司品德是纱的度量单位。
- The clerk put the check on a spindle. 店员将支票放到扦子上。
- The spindle seemed to be out of order. 心轴好像坏了。
- The brackets want an extra screw. 托架需要再加一个螺钉。
- The song of the spindle was silent. 纺锤的歌声沈默了。
- He chiseled a hole in the door to fit a new lock. 他在门上凿了个孔，以便装一把新锁。
