您要查找的是不是：
- But when it was more than 10, the effect of repeated dismounting times on both bi-screws holding and static bending strength was on the contrary. 但当重复拆装次数大于10次以后，随着拆装次数的增加，构件的静曲强度和双螺钉握钉力均呈现显著下降的趋势。
- The proper quantity of water selected may increase the static bending strength and decrease the transfiguration of plates. 选择合适的水分可以提高板材静弯曲强度,减小板材变形。
- In this test, air-dry woods of China-fir, Taiwan acacia, Lauan and Hemlock were used to monitor AB counts under static bending test. 本试验以杉木、相思树、柳桉及铁杉之气乾材为试材，测定静力弯曲试验时AE发生之情况，探讨AE发生次数与应力、应变之关系。
- Five specimens for three-point static bending tests, five for thickness swelling (TS) were cut from each board according to ASTM D1037-96. 五件样品为三个点的静电弯曲测试 , 五因为厚度增大 (TS) 从依照美国材料试验学会 D1037-96 的每董事会被减低。
- The results indicate that the oxido-decarbonisation on the surface makes the static bending yield strength decrease by 15%. 结果表明，表面层的氧化脱碳使静弯屈服强度降低15%25左右；
- In this paper the structure of the Joint 15 presented, the principle of pneumatics and method of control are described and the static bending model of the joint is analyzed. 给出了关节的结构，介绍了手指关节的气动原理与控制方法，并分析了关节弯曲变形的静态模型。
- Through analysing sunflower-stem filled plate structure and the stress due to static bending load on it. We have derived a formula for calculating the static bending strength, Here eletric-measure method is ued to check the accuracy of this formula. 本文通过对葵花杆填充板结构分析,静弯曲受力破坏应力分析,推导出了填充板静弯曲强度的理论计算式,通过电测法进行了验证。
- modulus of elasticity in static bending 弯曲弹性模量
- Static bending test for corrugated paperboard 瓦楞纸的静态弯曲试验法
- The modulus of elasticity in static bending of wood 木材静曲弹性模量
- Method of static bending test for full sized structural lumber 建筑结构用木材弯曲度测量方法
- Test methods for static bending fatigue of fine ceramics 精细陶瓷静态挠曲疲劳的试验方法
- I do not get any static on my set. 我的电视机没有静电干扰。
- The stream takes a sudden bend to the east. 小溪突然转向东流。
- The act or posture of bending low or crouching. 下蹲，蹲伏下蹲或蹲伏的动作或姿势
- She bend over backwards to show it. 她拼命把他显露出来。
- They refused to bend to the hijackers' demands. 他们拒绝屈从于劫机者的要求。
- Don't bend the wires down, it'll break them. 不要弯折那些线，会弄坏它们的。
- Touch your toes without bending your knees. 用手够到你的脚趾，膝盖别弯曲。
- That sharp bend is a death-trap for motorists. 那个急转弯是开汽车的人的死亡陷阱。
