您要查找的是不是:
- tractive force method 牵引力图解法
- It was also recognized that this force is a tractive force. 这种力量也被认为是吸引力。
- Many formulas appeared in literature since DuBoys(1879)presented his tractive force relation. 自杜波阿(1879)提出他的拖曳力关系式以来,文献中已经出现了许多公式。
- For highly cohesive sediment, the critical tractive force becomes less significant. 对于高粘性泥沙,临界推移力就成为不重要的。
- The real time calculation of tractive force and braking force is the core of the system. 它的核心是能够实时计算得到机车运行过程中的牵引力和制动力。
- Used indoor or outdoor able to bear external mechanical force, but the tractive force during laying.Laying sinle cor cable in magnetic duct is not permissible. 适用于室内外敷设。可经受一定的敷设牵引,但不能承受机械外力作用的场合。单芯电缆不允许敷设在磁性管道中。
- At dampy climate or after rain, there is a very thin water film on tyre tread or road surface, which causes motor vehicle tractive force reduction during driving. 在潮湿的天气或雨后,轮胎胎面或路面上存在一层很薄的水膜,该水膜使车辆行驶的牵引力降低。
- Through the drive axle housing , the tractive force 、 braking force and lateral force act on the wheel transfer to the suspension system 、 frame or carriage. 作用在驱动车轮上的牵引力、制动力和侧向力,也是经过桥壳传到悬挂及车架或者车身上。
- The force method of analysis can be applied to any structure subjected to loading or environmental effects. 分析的方法可适用于承受荷载或外界效应的任何结构。
- The periodic external force method has a better precision and it does not need absolute disp... 功率谱方法精度较高;且不需要测量出绝对位移;但是测量结果受到系统噪声影响较大.
- This paper solved out link moments of each edge of arch folded plate structures with force method of elemental plate based on the reference. 本文在文献(1)基础上;用单元板力法求出拱型折板结构的棱边弯矩.
- The force method, which is introduced the concept of surface force density of membrane element, is used to find the form of tensility strcutres. 考虑膜单元的面力密度的力法找形方法,通过调整面力密度能够获得不同形状的曲面。
- Generalized inverse matrix (GIM) is a new force method based on the generalized inverse matrix theory, which is an iteration method for solving material nonlinear problems. 摘要广义逆力法是一种以力法为力学概念基础,以广义逆矩阵理论为数学理论基础,以迭代求解为求解方式的新算法。
- tensile strength; tractive force 拉力
- In thes paper, Body Force Method (BFM) with special fundamental soluhons and resultant bountw condihons is employed to analyze the problem of an adhesively bondedcracked plate. 使用一满足胶贴层位移连续条件的剪切单元,把问题转化为对裂纹板和贴片的分析。
- The steering ability of BHA in build up section of horizontal well Shugu 11 has been predicted and analyzed by balanced side force method and SABHA software. 利用平衡侧向力方法和SABHA软件系统,对曙古11水平井定向造斜段钻具组合的导向能力进行了预测分析。
- To consider the distribution of the braking and tractive forces among the piers and abutments proportional to their shear stiffness is the basic principle in the design of flexible piers. 本报告论证了柔性墩设计理论的基础是考虑墩与梁、台的共同作用,分析了柔性墩设计理论的五个特点,从而说明了柔性墩能节省大量圬工的原因。
- In this paper the maximum cohesive force method (MCFM) is adopted to carry out the component design of asphalt stabilized base and compared with conventional Marshall method. 摘要采用最大粘结力法设计沥青稳定基层的配合比,并与传统的马歇尔方法进行对比。
- This paper analyzes the forming mechanism of Lawu Landslide and adopts the remaining push force method to calculate the stability under two circumstances. 文章分析了云南省宾川县拉乌滑坡的形成机制,并对滑坡在不同工况下采用剩余推力法进行了稳定性计算。
- Tractive force design of tracked robot based on skip-steering model 基于滑动操作模型的履带机器人驱动力设计