您要查找的是不是:
- transition temperature chamber 变温舱
- Niobium is the metallic element with the highest transition temperature. 铌是转变温度最高的金属元素。
- In addition, many suspected that 23 K was close to the maximum transition temperature possible for a traditional superconductor. 此外很多人也认为,23K已经接近传统超导体最高转变温度的极限。
- The point groups above and below the transition temperature are Amm and m respectively. 相变温度上下晶体点群分别为4mm和m。
- We defined the transition of FCGR as a fatigue ductile-brittle transition temperature (FDBTT). 本文将疲劳裂纹扩展速率发生转折的温度定义为疲劳裂纹扩展的韧脆转化温度FDBTT。
- The crystalline pattern of Chestnut starch was C and the glass transition temperature was 147.7C. 板栗淀粉的晶型属于C型,板栗淀粉的玻璃化转变温度为147.;7℃。
- DSC, which verified the transition temperature of LC phase,detected two of them, other related tests are in progress. 其中两个化合物做了差热分析(DSC)测试,证实有液晶相变化出现,其它相关测试在进行中。
- The glass transition temperature(Tg) of HBPS-1, HBPS-2 and HBPS-3 were studied by DSC. 示差扫描量热法(DSC)的分析结果表明:HBPS-1、HBPS-2、HBPS-3的玻璃化转变温度按顺序降低,且均低于线形聚苯乙烯的玻璃化转变温度;
- The results show the existence of a characteristic transition temperature of coking process in TLE. 反之,表面缩聚反应过程为控制步骤。
- The glass transition temperature of the WPC does not change after about 1000 hours under high temperature. 木塑材料在经历了近1000小时的高温老化后,其玻璃化温度几乎不变。
- The FE-AFE temperature decreases and the AFE-PE transition temperature increase with hydrostatic pressure increasing. 随着压力增大,铁电-反铁电相变温度降低,反铁电-顺电相变温度升高。
- Warming up time of high temperature chamber 高温室升温时间
- All polyesters have low phase transition temperature, they have good solubilities in common organic solvents. 所有聚酯均具有较低的相转变温度,在普通的有机溶剂中具有较好的溶解性质。
- The liquid crystal phase states and phase transition temperature and hysteresis loops proved their ferroelectricity. 经元素分析和红外光谱分析确证了其结构,并进行了相态、相变温度和电滞回线的测定,证实其为铁电液晶。
- The influence of emulsion particle size and glass transition temperature, etc on film performances is discussed. 讨论了丙烯酸酯乳液的粒径大小、玻璃化转变温度等对涂膜性能的影响。
- The glass transition temperature and the thermal decomposition of PDLLA were determined by DSC and TGA. 用DSC,TGA分析了不同分子量PDLLA的玻璃化转变和热失重。
- And the DSC thermograms demonstrate the same tren d of theglass transition temperature of the modified resins. 测定了改性产物的DSC曲线,发现随着反应物中对氨基苯甲酸比例的提高,改性产物的玻璃化转变温度升高。
- During the air pressure test, the test temperature shall be higher than the brittle transition temperature of the metal material. 气体压力的试验时,试验温度必须高于金属材料的脆性转变温度。
- Cooling down time of low temperature chamber (first) 低温室降温时间(首次)
- The experimental results show that water jet impingement induces higher heat flux, higher critical temperature and narrower transition temperature range. 水冷实验数据分析结果表明:射流能提高热流密度和临界温度,缩小过渡区温度区间。