您要查找的是不是：
- vertical wheel contact force 垂直接地力
- Simulation results show that vertical dynamic contact force is some two times of static wheel load F0, which agrees well with the present spot test result. 通过分析发现，车轮和轨道之间的竖向动态接触力大约是静轮载的2倍，与已有的现场试验结果基本吻合。
- Increases in torque transmission are achieved due to axial contact force. 通过轴向压紧力,可提高转矩
- Vertical wheel/rail contact force 轮轨作用力
- The edges of all steel components are beveled and polished, and each tooth of each gear wheel is manually polished with a rotating hardwood disk to reduce friction at the wheel contact points. 所有的不锈钢部件边缘都被倒角抛光，并且每一个齿轮的齿都被硬木转盘手工旋转抛光以减小齿轮接触点间的摩擦。
- During the walking, the maximum contact force is 2644N, about 2.99BW, and the maximum ligament tensile force is 595N, whichhappened in the MCL. 在平地行走时;膝关节的最大接触力大小为2644N;约为人体重的2.;99倍(BW);最大韧带张力大小为595N;发生在MCL上。
- This has made the measurement of the contact force of catenaries-pantograph system become the most significant project. 这使得接触网-受电弓之间的接触力成为最重要的检测项目。
- Augmented Lagrangian method was specified calculating normal contact force, Coulomb friction law was specified calculating tangent contact force. 采用扩展的拉格朗日算法计算法向接触力,库仑摩擦定律计算切向接触力。
- Based on the model,DHD(Delta Haptic Device) is able to reveal the contact force through touching the virtual soft object. 在此模型的基础上,利用DELTA手控器,对柔性物体接触变形以及实时虚拟力反馈进行半物理仿真。
- Lankarani H M, Nikravesh P E. Continuous contact force models for impact analysis in multibody systems [J]. Nonlinear Dynamics, 1994, 5:193-207. 阎绍泽贾书惠.;含间隙的变拓扑多体系统动力学建模分析[J]
- Because of the reaction force of the soil foundation, the hammer rebounds to some distance, that makes contact force appear discontinuous character. 由于地基土的反力作用使得夯锤发生一定的弹起,故强夯接触力具有强间断性的特征。
- The denucleation and degeneration of intervertebral discs might increase the facet contact force and it is quite disadvantage to the facet joints under vibration conditions. 椎间盘的去核与退化将使小关节的接触力增加，在振动情况下对小关节非常不利。
- By using the equivalent model,contact force of ideal trochoid transmission was calculated,and the calculation result agree relatively well with a theoretical one. 利用质量弹簧等价模型方法计算了理想结构下摆线针轮传动的齿面载荷分布。
- The vertical line meets the horizontal one here. 垂直线与水平线在此相交。
- In the experiment, contact force of unconfined particle layer in the impact crushing course was measured and the contact parameters were estimated based on bilinear contact model. 试验结果表明,有物料层的钢-物料层-钢冲击破碎,其恢复系数和接触刚度远小于无料层的钢-钢冲击,并随物料层厚度的增大而减小,但物料粒度的影响较小。
- If I fall asleep at the wheel wake me up. 如果我开车时睡着了，就叫醒我。
- Using this model, the deformation of the virtual object was simulated, and synchronously the real-time virtual contact force was provided with DELTA haptic device. 基于此力变形模型，利用DELTA手控器，进行了柔性物体接触变形以及实时虚拟力反馈的半物理仿真。
- My wheel twisted off in the middle of the car race. 我的车轮子在汽车比赛中途脱掉了。
- Based on a group of basic equations, the calculation of roll shape is greatly simplified under the restriction of equal contact force between work rolls and backup rolls. 基于一组基本方程，并以工作辊、支持辊间接触压力相等为约束进行计算，从而使计算过程大为简化。
- His father is a big wheel in the government. 他的父亲是政府里的要人。
