您要查找的是不是:
- Now RCM and CCM of channel 1 HI have no voltage across them. 现在,通道1的HI线路上的RCM和CCM上没有电压。
- The voltage across the capacitor is a few tenths of a volt. 这个电容器上的电压为零点几伏。
- As the voltage across a resistance is changed ,the current changes . 电阻的电压变了,电流也变了。
- USING AN VOLTMETER, MEASURE THE VOLTAGE ACROSS THE RR WSS AND TERMINALS. 用电压计,测量右后SS和(−)端子。
- As the voltage across a resistance is changed , the current changes . 电阻的电压变了,电流也变了。
- The error amplifier and optocoupler, IC1, monitors the voltage across C3. 误差放大器和光耦IC1通过C3监控电压。
- Since all three elements are in parallel, they mustall have the same voltage across them. 由于三个元件都是并联,它们的端电压必然相同。
- Since all three elements are in parallel, they must all have the same voltage across them. 由于三个元件都是并联,它们的端电压必然相同。
- By applying a voltage across the electrodes of a pixel, the polymer can be made to absorb or expel some of the electrolyte and thus expand or contract. 通过把一个像素的正负极输入电压,聚合物就能被加工成一种吸收或排除某些电解液的物质,这样它也就会增大或缩小。
- While it is charging, a voltage comparator constantly compares the voltage across the capacitor to a reference voltage. 晶体管提供了类似让吊桶倾倒的作用--每当被触发时它就使电容短路。
- The AC voltage across the capacitor at which the discharge magnitude is less than the given magnitude qg. 降压过程中;观测到放电量低于某个规定值的最高电压值.
- The unique output full-bridge incorporates source-side linear operation to allow a constant voltage across the motor coil. 独特的全桥式输出整合源端线性操作,可确保电动机线圈的持续电压供应。
- The voltage across RL1 is the picoammeter voltage burden, normally less than one millivolt, so the resulting current will be quite small. RL1上的电压为皮安计的输入端压降,通常小于1mV,所以产生的电流是相当小的。
- The seriesresonance also magnifies the voltage across the work coil, far higherthan the output voltage of the inverter alone. 在工作线圈中间,通过电流可以产生一个剧烈并且飞速变化的磁场。
- The voltage across RL1 is the picoammeter voltage burden, normally less than 1mV, so the resulting leakage current will be quite small. RL1上的电压为皮安计上的电压降,通常不到1mV,因此产生的电流非常小。
- The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly. 然后仪表通过同一套测试引线来测量电阻两端的电压,并计算出相应的电阻数值。
- The value of the unknown resistance is computed from the sense voltage (VM), the voltage across clamping resistor (VSH), the known value of RSH, and the source current. 未知电阻的数值可以由取样电压(VM)、钳位电阻器上的电压(RSH)、已知电阻值(RSH)和源电流计算出来。
- When the voltage across CX equals VREF2, comparator C2 changes state causing the output latch to reset (Q goes low) while at the same time disabling comparator C2. 当电容两端的电压等于VREF2时,C2改变状态,造成输出锁存器重置,同时关闭C2.
- The effect of transmission line on voltage across the load resistance at test port is approximated as cascade of parallel C and series L circuit model of many small line segments. 以非常小于波长短线段之并联电容与串联电感串接电路模型近似量测端负载之上电压因传输线长度之影响。
- He beckoned to me from across the street. 他在马路对面向我招手致意。