您要查找的是不是：
- A warp yarn should be strong, elastic, extensible and smooth. 经纱应该强度高、弹性好、伸长率高,而且表面光滑。
- To remove the size coated before weaving on warp yarn. 去除织布之前已涂在经纱上的浆。
- The warp let - off motion allows the feeding of warp yarn under uniform tension and at the proper rate. 送经机构可以使送出的经纱保持均匀的张力并保证准确有送经量。
- In this system, the warp yarns are fed to the loom. 在该系统中,经纱被送入织机。
- The warp let...off motion allows the feeding of warp yarn under uniform tension and at the proper rate. 送经机构可以使送出的经纱保持均匀的张力并保证准确有送经量。
- This paper analyzed the cause of warp yarn hairiness of T/C fabric and its influence on weaving. 分析了涤棉织物经纱毛羽产生的原因及对织造的影响,介绍了降低纱线毛羽的具体上浆措施。
- The major advantage of the Jacquard attachment is its ability to control each individual warp yarn instead of a series as in regular harness looms. 提花机构的主要优点是：它可以控制每根经纱,而不是像使用综框的常规织机那样控制一批经纱。
- To make the process of weaving continuous, the warp yarn must be continuously supplied and the woven fabric must be removed. 为了使织造过程顺利进行,必须连续地供应经纱,形成的织物必须被引离。
- The nylon-cotton elastic and sparkling fabric is composed of nylon lustrous filament as warp yarn and cotton-polyurethane core-spun yarn as weft yarn. 锦棉弹力闪光交织物经向为锦纶有光丝,纬向为棉氨纶包芯纱。
- Weaving in which the warp yarns are paired and twisted. 纱罗织法将经纱线匹配并扭织在一起的织布方法
- The let-off and take-up mechanisms of the weaving machine were modified.The creel let-off mechanism could meet the requirement of unequal warp yarn length of this fabric. 改造了现有织机的送经和卷取机构，采用纱架送经可满足仿形织物经纱不等长的要求；
- This paper analyzed the cause of warp yarn hairiness of T/C fabric and its influence on weaving.It also introduced the concrete sizing measures on reducing hairiness. 分析了涤棉织物经纱毛羽产生的原因及对织造的影响,介绍了降低纱线毛羽的具体上浆措施。
- The shedding and beating- up cause cycle tension variations in the warp yarns. 开口运动和打纬运动会引起在一个织造循环内的经纱张力波动。
- The warp yarn goes over, or floats over, two filling yarns and under one in the 2/1 twill. 斜纹组织中,经纱位于(或浮于)两根纬纱之上,然后位于一根纬纱之下。
- Based on double back-bearer system of new looms,it analyzes the tension distribution of all partsas well as the warp yarn between the warp course,then sets up the tension model of the yarn. 以双后梁系统的新型织机为基础,分析经纱回路各个部件的受力情况和经纱的形变情况,建立经纱张力模型。
- The existence of shear deformation makes the maximum and minimum radii of the annular fabric on the loom are smaller than those of designed, but the warp yarn density becomes greater. 剪切变形的存在，使机上圆环形织物的大小半径比设计值要小，而经纱密度变大。
- The beggar spun a long yarn about his misfortunes. 那个乞丐编造了一大篇自己如何遭遇不幸的故事。
- Because of this, some friction will exist between the shuttle and the warp yarns near the selvages. 因此在布边附近,梭子和经纱之间会存在磨擦。
- The geometry models are used to calculate the length of yarns,the orientation angle of the nodulated yarn vs warp yarn and the fiber vo... 在此基础上计算了纱线长度、接结经与经纱的取向角和纤维体积含量;通过几何极限条件定义了织物紧度,为进一步研究其力学性能奠定基础。
- The weavability of the warp yarns is largely influenced by the quality of grey yarn, the quality of preparation and the weaving condition. 原纱质量、经纱准备、织造条件是影响经纱可织性的重要因素。
