您要查找的是不是：
- Generator Belt Tension Adjust Bracket 发电机皮带张力调整托架
- Check and repair radiator and thermostate; adjust the fan belt tension. 检查并修理散热器、调温器，调整风扇皮带张紧力。
- The 0.5 hp motor was mounted on vertical rails at the back of the headstock-end leg and could be moved up and down, to adjust the belt tension. 0.;5马力电机安装在垂直导轨背面的启闭年底腿，可以向上和向下移动，以调整皮带的紧张局势。
- The waviness is mainly depending on the belt tension. 该波纹是主要依靠皮带张力计。
- belt tension adjusting facility 皮带张力调节设备
- Fine tension adjustment with eccentric gear. 偏心齿轮式张力微调。
- If thread is wound unevenly, move winder tension adjust base 3 to the right.or left until it is correctly positioned. 绕线时，请左右移动绕线张力杆座3，设定到正确的绕线位置。
- For belt tension specifications, refer to Specifications-Accessory Drive Belt in this group. 关于皮带张力规格表，请参见本单元的规格表-辅助驱动皮带
- If thread is wound unevenly, move winder tension adjust base 3 to the right or left until it is correctly positioned. 绕线时,请左右移动绕线张力杆座3,设定到正确的绕线位置。
- The lab test result shows that this system is feasible for dynamic test of belt tension. 系统能实现输送带静止及运动过程中的沿线张力测试。
- The tension adjuster is an important equipment in the transport system atthe work line of electron beam radiation cross-linking wire and cable torealize the velocity synchronism. 张力调节装置是电子束辐照交联电线电缆生产线传输系统实现速度同步的关键部件。
- Some movement of sprockets and timing marks as belt tension is adjusted is normal. 当调整皮带张力时，链轮与正时记号有些许移动是正常的。
- Usually the same belt drives the alternator, and belt tension is adjusted by swinging the alternator on its mounting. 通常将一台机器的皮带换到另一台机器的时后，带的张紧力需要通过调节安装来调节。
- Loosen the accessory drive belt tension and remove the belt from the power steering pump (refer to Group 07, Cooling Systems for proper procedures). 放松辅助驱动皮带，从动力转向泵上拆下皮带（有关程序，请参阅单元07，冷却系统）。
- End Cap: Belt Tensioning System, easy access, easy adjustment. 完第：皮带张紧系统，方便，调整方便。
- If this is not the case, the bearing must be subjected to an additional radial load, e. G. By increasing belt tension or idling torque, or by other means. 否则必须给轴承施加径向载荷,例如,通过提高皮带张力或空转扭矩,或采用其他手段。
- Based on PLC,the closed loop control system design with transducer timing and the tension adjust by PID,can satisfy the craft of the full-automatic production request of the paper core consecution. 基于PLC具有PID调节的变频调速和张力调节闭环控制系统设计方案,能满足纸芯连续全自动生产的控制要求。
- Back off tensioner adjusting nut to create slack in cables. 旋下拉伸器调整螺帽使钢缆松弛。
- In this paper the author discusses calculation of belt tension and selection of mo-tor power of sandwich belt conveyor with large inclination,conditions at which the two motorsrun synchronously. 讨论了大倾角压带式输送机输送张力的计算、电机功率的选择及两电机同步运行的条件。
- According to the belt tension analysis of the large near-horizontal and upstroke conveyor during braking and starting,this paper gives the effects of brake location on the take-up tension. 通过近水平和上运大型带式输送机制动工况和起动工况的张力分析,明确了制动装置位置对输送带张紧力的影响,进而提出大型输送机制动与张紧装置的优化布置方法。
