您要查找的是不是：
- Application of heating spray in the heating pipe line of boiler 热喷涂在锅炉加热管路中的应用
- Harbin DawnHappy Heat Pipe Technology., Inc. 哈尔滨晨怡热管技术有限公司。
- Debris in pipe line is too fine to be trapped by strainer. 管线内的碎片太细小导致过滤器无法截留。
- DWTT separation fracture has been analyzed for pipe line steel. 摘要文章对管线钢DWTT试样上出现的分离断口进行了分析。
- Capabilities and management of a heat pipe cooling device. 加热管制冷设备的功能和管理。
- Maximum continuous flow based on pipe line velocity of 20 ft. per second. 最大持续流量以管路流速每秒20英尺为计算基础。
- Prior to installation, thoroughly flush pipe line to remove any foreign matter. 在安装之前,彻底冲洗管线,清除任何外来物质。
- The heat pipe shall be packaged not to be damaged in transportation. 热管在运输过程中包装不应受到破坏。
- Technical and Economic Analysis on Design of Production Pipe Line of C.P.P. 选煤厂生产管道设计的技术经济分析。
- Maximum intermittent flow based on pipe line velocity of 25 ft. per second. 最大间歇流量以管路流速每秒25英尺为计算基础。
- Clear pipe line with pressurized steam before installation steam trap. 安装疏水阀之前应用带压蒸汽吹扫管道。
- Technology: flange type of heating is heating pipe and welding flanges from fixed. 工艺：法兰式加热管是由加热管与法兰焊接固定而成。
- A novel heat pipe biomass gasifier was developed to improve the heating value of gas produced. 摘要为了提高生物质燃气热值，开发一种新型热管生物质气化炉。
- Protective gas system: pipe line from the protective gas generation station to reducing annealing furnace. 保护气系统:从保护气体发生站至还原退火炉的管道。
- After installation of valve, support the pipe line; a sagging pipe line can distort the valve and cause failure. 在安装阀门后，要对管道加上支撑物，否则下垂的管道可能会使得阀门变形并造成故障。
- The dimensional attributes of this heat pipe shall conform to the following drawing. 热管的直径及大小和下图一致。
- Swing Check valves prevent reversal of flow through pipe lines. 旋启式止回阀可以防止管路中的流体倒流。
- The study of high freezing-rate facilities using Natural Coldness Resource (NCR) was analyzed according to the heat pipe technique in this paper. 摘要通过试验并加以理论分析，研究开发高结冰率的自然冷源贮藏设备。
- The expert KBS of heating pipe network failure diagnosis system was established via the results of failure simulating experiments. 通过对故障模拟实验结果的分析，进一步建立起供热管网故障诊断的系统专家知识库。
- After installation of valve, support line; a sagging pipe line can distort valve and cause failure. 安装阀门后，要支撑住管道：下垂的管道会使阀门产生变形而导致失败。
