您要查找的是不是:
- Early lock washer on left, as used on the 600 series. 左边是早期的固定垫圈,使用在600系列上。
- To replace diaphragm; loosen lock nut (48) and remove lock washer (46), diaphragm plate (60) and diaphragm (20). 要更换隔膜,先松开锁紧螺母(48),并拆卸锁紧垫圈(46),隔膜板(60)和隔膜(20)。
- Hold stem (27) on wrench flats and remove nut (51), lock washer (46), diaphragm plate (60) and diaphragm. 在扳手的平面上握住阀杆(27)并拆卸螺母(51),锁紧垫圈(46),隔膜板(60)和隔膜。
- Loosen and remove the diaphragm lock nut and lock washer, pressure plate and diaphragm from the valve stem. 松开和拆卸隔膜锁紧螺母和锁紧垫圈,从阀杆上往下压阀盘和隔膜。
- Disassemble module. Use wrench to loosen stem nut and remove lock washer and diaphragm plate. Remove yoke by loosening disc holder using a screw driver. 拆卸模块。使用扳手松开阀杆螺母,并且拆卸锁紧垫圈和隔膜板。采用螺丝刀,通过松开阀瓣支架来拆卸轭架。
- Slide and tap in reservoir retainer clips until tab locks to housing. 滑动并敲击贮油槽扣件夹,直至凸耳锁紧外壳。
- Smaller sizes use a lock nut with a locking washer (a), larger sizes use a nut with locking clip (b). 小尺寸轴承使用带锁紧垫圈的锁紧螺母(a)大尺寸的轴承使用带锁紧卡箍的锁紧螺母(b)。
- Single coil spring lock washer for assembly 组合件用弹簧垫圈
- lock washer with tongue at outside 外舌止动垫圈
- Hangzhou Zhengda Spring Lock Washer Co., Ltd 杭州正大弹簧垫圈有限公司
- Serrated lock washer external teeth for assembly 组合件用外锯齿锁紧垫圈
- front wheel bearing nut lock washer 前轮毂轴承螺帽锁紧垫圈
- lock washer with tongue at inside 内舌止动垫圈
- Lock washers with angular upturn tab perpendicular to the lug GB/T1021-1976角形垂直单耳止动垫圈
- Lock washers with angular upturn tab in line to the external tab GB/T1024-1976角形外舌止动垫圈
- Countless washer women have rubbed the stone away. 无数洗衣者的搓洗将那块石头磨掉了。
- Lock washers with angular upturn tab in line to the lug GB/T1022-1976角形单耳止动垫圈
- You can open the can by pulling the tab. 你可拉拉环把罐头打开。
- The company picked up the tab for our trip. 公司为我们支付了旅行开支。
- The washer for preventing leakage is broken. 那个防漏的垫圈坏了。